- ページ 8

カメラアクセサリー Dynamis lead-lineのPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。Dynamis lead-line 16 ページ。 Sealed lead acid batteries

4. Operation of sealed lead acid batteries

4.1 Preparation prior to operation



Batteries should always be fully charged prior to use, especially when use it

for the first time right after purchasing or after long period storage. Batteries

after long period storage will lose some capacity due to self-discharge, and

need recharge to restore its full performance.



Do not put sealed lead acid batteries in airtight containers, or install the

batteries in a room without ventilation. Gas generated by over charging

reactions in the battery may explode if ignited by sparks from machinery or

switches.



Tightly screw the connector with the terminal of the batteries.



Do not lay a metallic object on top of a battery.



Insert insulation that is acid and heat resistant between the batteries and any

metallic housing.



Do not charge the battery with upside down position, it may cause acid

leakage.

Batteries must be stored or used in the temperature range of:



Charging:

Discharging: -15°C ~ +50°C

Temperatures above or below these ranges could result in damage or deformity

of the battery.

4.2

Charging methods for standby use batteries



The purpose of charging standby use batteries is to compensate

self-discharge. The constant voltage charging method is commonly applied.

Standby batteries are continuously overcharged at a voltage only slightly



above their open circuit voltage, called float voltage. The low float voltage

DYNAMIS Batterien GmbH

Tel. +49 7735 93669-0

0°C ~ +40°C

Brühlstr. 15 D-78465 Dettingen / Konstanz

Fax +49 7735 93669-91

www.dynamis-batterien.de

04.12.2006

Page 8 of 15