- ページ 3

バッテリーチャージャー Dynamite DYN4058のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dynamite DYN4058 4 ページ。 Li-po charger

ページを印刷する

Charging Process

Step 1: Connect the battery to the charger. The charger will

signal the connection of the battery by producing one long

beep. The LED will also flash indicating the connection of

the battery.

Step 2: Press the Cell Selection/Start Button to choose the

proper cell count to match your battery pack.

Step 3: Refer to the chart below for recommended charge rates.

Select the appropriate charge rate for your particular battery by

actuating the Charge Rate button.

Battery Capacity

500mA–1000mA

1000mA–2000mA

2000mA and above

Warning: Selecting a charge rate higher than 1x battery

capacity may result in fire.

Step 4: Push and hold the Start button for two seconds. You will

hear a short beep, and the LED will remain on continuously to

indicate the battery is charging.

Note: Do not adjust the charge rate switch in this state.

Note: The charge cycle can be canceled by pressing the

Start button again. The charger will produce a short beep

to indicate the end of the charge cycle, and the LED will

again flash.

• The charger will detect the cell count to make sure the correct

cell count has been selected. If not, the charger will emit an

error tone and all the charge LED' s will flash.

• If the battery voltage is too low, the charger will also emit

the error tone even though the right number of cells has been

selected. Hold the CHARGE button for 2 seconds to enter the

charger into the low voltage charge mode. After 30 seconds the

charger will return to the correct charge mode.

Step 5: When charging is complete, the charger will emit one

long beep, ten double-beeps and then the LED will flash.

The beeper will sound every 45 seconds until the battery is

disconnected. Do not leave the battery connected to the charger

when charging is complete. Failure to comply may result in fire.

Charge Rate

500mA

1000mA

2000mA

Warranty

Limited Warranty Period

Horizon Hobby, Inc. guarantees this product to be free from

defects in both material and workmanship for a period of 5 years

from the date of purchase.

Limited Warranty & Limits of Liability

Pursuant to this Limited Warranty, Horizon Hobby, Inc. will, at

its option, (i) repair or (ii) replace, any product determined by

Horizon Hobby, Inc. to be defective.

In the event of a defect, these are your exclusive

remedies.

This warranty does not cover cosmetic damage or damage

due to acts of God, accident, misuse, abuse, negligence,

commercial use, or modification of or to any part of the

product. This warranty does not cover damage due to improper

installation, operation, maintenance, or attempted repair by

anyone other than an authorized Horizon Hobby, Inc. service

center. This warranty is limited to the original purchaser and

is not transferable. In no case shall Horizon Hobby' s liability

exceed the original cost of the purchased product and will not

cover consequential, incidental or collateral damage. Horizon

Hobby, Inc. reserves the right to inspect any and all equipment

involved in a warranty claim. Repair or replacement decisions

are at the sole discretion of Horizon Hobby, Inc. Further, Horizon

Hobby reserves the right to change or modify this warranty

without notice.

REPAIR OR REPLACEMENT AS PROVIDED UNDER

THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE

CONSUMER. HORIZON HOBBY, INC. SHALL NOT BE LIABLE

FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES.

As Horizon Hobby, Inc. has no control over use,

setup, final assembly, modification or misuse, no

liability shall be assumed nor accepted for any

resulting damage or injury. By the act of use, setup or

assembly, the user accepts all resulting liability.

If you as the purchaser or user are not prepared to accept the

liability associated with the use of this product, you are advised

to return this product immediately in new and unused condition

to the place of purchase.