- ページ 3
ドライヤー DBK Drymatic Boost Bar FGPH109のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DBK Drymatic Boost Bar FGPH109 16 ページ。 Adaptable heat drying system
DBK Drymatic Boost Bar FGPH109 にも: 取扱説明書 (18 ページ)
HANDLE WITH CARE!
RISK OF ELECTRIC SHOCK!
•
Do not alter or modify your Drymatic Boost Bar in any way. Use only replacement parts approved by
DBK. Modifications/repairs not covered in the maintenance section of this manual and the use of
unapproved parts will void any remaining warranty.
•
Do not remove adhesive labels.
•
Only use Drying Mats/accessories branded by Drymatic or DBK. Ensure air movers match the Boost
Bar inlet size: recommended airflow is 650cfm (1100m³/hr) (Manufacturers recommended airflow)
•
Maximum Airflow (tested) 1560cfm (2650m³/hr)
•
Handle the unit carefully. Always operate the unit on a flat stable surface. Do not drop, throw or place
the unit on a surface from which it could fall off. Rough handling may damage the unit, create
dangerous operating conditions and will void the warranty.
•
Never pull or lift the product via the power cord.
•
Children should be supervised to ensure they do not play with the appliance.
•
The appliance is not intended for use by persons (including children) with reduced physical, sensory
and mental capabilities or lack of experience or knowledge, unless they are supervised by an adult.
•
If the power cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard. Always grasp the plug (not the cord) to unplug and avoid
pulling or lifting the product via the power cord.
•
Do not use with worn electrical outlets as the plug will become excessively hot. The heater shall not
be located immediately below a power outlet.
•
Do not use this heater in small rooms when they are occupied by persons not capable of leaving the
room on their own, unless constant supervision is provided.
•
Do not overload outlets or extension leads - Check power ratings and condition before use. Always
fully unwind extension leads.
•
It is recommended to run the unit on a 120V supply circuit protected by a Ground Fault Circuit
Interrupter (GFCI) or a RCD. It is also recommended to regularly PAT (Portable Appliance Test) the
machine. Only replace fuse with a 15A, 500V ceramic type as marked on the unit.
•
In order to avoid overheating, do not cover the entire unit. Ensure that when mats deflate they do not
cover any equipment/outlets causing a hazard.
•
Do not use in the immediate vicinity of a bath, shower or swimming pool. Avoid standing water or
locations where water can run or drip on to the unit.
•
Keep away from open flames and heat sources or where vapors from gasoline, solvents, thinners or
any other flammable materials may be present.
•
Do not block either Boost Bar outlet/inlets. This could cause the unit to overheat and limit airflow.
•
For commercial use only, not for use on building sites.
•
Do not dispose of in municipal solid waste.
•
Stacking is for storage purposes only, do not use units when stacked or stack other equipment on top.
IMPORTANT SAFETY INFORMATION:
KEEP AWAY FROM CHILDREN!
RISK OF BURNS!