- ページ 9
アンプ Hifonics BXi1600 DのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Hifonics BXi1600 D 12 ページ。 Brutus bxi amplifier series
ページを印刷する
Monoblock-Amplifier- Functions and Controls
BXi 750 / BXi 1100 D / BXi 1600 D
LOW PASS/SUB SONIC
LOW PASS - Controls the frequency response of your speakers upwards and is continously
variable from 35Hz to 250Hz.
SUB SONIC - Eliminates the lowest frequencies to protect the speakers from damages. These
low frequencies can cause damages. The frequency is adjustable from 15 Hz to 35 Hz.
Level -
This allows you to
match the input sensitivity
from 9 Volts to 0,2 Volts.
Phase -
This allows you to
match the
Phase from 0° to
180°.
LINE INPUT---BALANCED---SUBSONIC---BASS EQ---REMOTE---LOW PASS---PHASE---LEVEL---POWER---LINE OUT
L
R
I
Line
nput -
Full range line input
connect with the
Head unit.
Balanced Input -
Connect Head unit and
amplifier with a line driver
cable.
(a line driver is needed)
Bass EQ -
Allows you
to adjust the bass boost
from 0dB up to 18dB at
45 Hz
INPUT
15Hz
35Hz 0dB
18db
35Hz 250Hz 0
Remote -
for remote control.
Allows you to adjust the
subwoofer from your
Protect - LED
Red LED is illuminated:
a) Overheated
b) Speaker wires shorted
c) Overload (Impedance, less Power)
d) Amplifier is damaged
Should the amplifier go into proteciont mode, simply
disconnect all RCA and speaker leads, while
keeping +12 volt, power ground and remote leads
connected. Now turn the amplifier back on, and if
the PROTECT-LED lights, the amplifier has an
internal fault. If not, plug the RCA cables back, and
reset the amplifier. If it goes into protection mode
now, the fault lies in the input, either with bad cables
or source unit. If the amplifier seems fine with RCA
cables plugged in, connect the speakers, one at a
time, and if one of the speakers or its wiring is faulty,
it will activate the diagnostic system.
Line Out - Full range
output that allows you
to use additional
amplifiers.
Power - LED
Green LED is illuminated
amplifier is on.
LCH
180 9V
0.2V
PROTECT
RCH
Connection
9