- ページ 2
メディア・コンバーター Dynamix HP-51/MのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dynamix HP-51/M 2 ページ。 Coax mdu master bridge
ページを印刷するPacking List
The contents:
♦ One Main Unit (DYNAMIX HP-51/M)
♦ One DC 5 V Power Adapter
♦ One F-Type Male-to-Male Coaxial Cable
♦ One RJ-45 Ethernet Cable.
Rear Panel
Figure 1: Rear Panel DYNAMIX HP-51/M
Connectors
1. DC5V: Connect to the power adapter plug.
2. LAN1/LAN2: Two fast Ethernet ports to
connect Switch / FTTx / xDSL Modem for
Internet access.
3. Reset: While the bridge is turned on, press
and release this button will reboot the bridge.
Press it for lasting 5 seconds will restore all
settings to factory default. For example, the IP
address will restore to default "192.168.1.1".
4. HCNA: Attach to existing coaxial cable and
use the cable as networking backbone in one
or more MDUs DYNAMIX HP-51/M. The
DYNAMIX HP-51/M is the HCNA master
device and controls the other HCNA endpoint
devices (refer to EP, as DYNAMIX HP-51/S)
on the same coax network.
5.
TV/Antenna: Connect to TV set. Or
connect to VHF/UHF antenna or CATV to
bypass TV signal to HCNA port.
LED Indicators
Status
LED
Glowing
Dimming
Powered by
Not powered
Power
DC5V
LAN1
Disconnect or
LAN1
Link up
Link fail
LAN 2
Disconnect or
LAN2
Link up
Link fail
HCNA
Disconnect or
Link/A
Link up
Link fail
ct
Synchronous
SyncM
Bridge failed
Mode
ode
Diagnosing
Not running
Diagno
EPs
Diagnosis
sis
NOTE: HCNA always adopt the Synchronous
MAC protocol layer in coax network in order to
coordinate all the transmissions and eliminate any
collisions. It works as head-end device in one coax
MDU network.
Connecting the Cables
Figure 2: Cabling example 1 of the Bridge
Figure 3 shows the connection by other
Combiner or Mixer-Splitter with the bridge.
Flashing
N/A
Receive or
Transmit
Receive or
Transmit
Receive or
Transmit
N/A
N/A
Figure 3: Cabling example 2 of the Bridge
Configure by Web Browser
The factory default
DYNAMIX HP-51/M bridge is "192.168.1.1"
and
the
"255.255.255.0". To access the bridge with
default IP, your PCs IP address should be as
"192.168.1.xxx". For instance, you may
connect one PC with the bridge directly by one
Ethernet cable between your PC's Ethernet
adapter and the bridge's port LAN1. Also
configures your PC's TCP/IP setting to fixed IP
as
"192.168.1.xxx",
"255.255.255.0", disable DHCP option. Make
your PC and the bridge within the same
"192.168.1.xxx" network. Type in
in your browser's website navigating field, as
the following:
IP address of the
default
subnet
mask
is
subnet
mask
as
192.168.1.1