ページを印刷する
6. Starting a Washing Programme
Wash cycle table
Cycle Selection
Programme
Information
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
been sitting with dried food
Intensive
on them for a while.
For normally soiled loads,
such as pots, plates, glasses
Eco
(*E 50242)
N
and lightly soiled pans.
(Standard
standard daily cycle.
Programme)
Light wash cycle to be used
for more delicate items which
are sensitive to high
Light
temperatures.(Run cycle
immediately after use)
For lightly soiled loads, such
as plates, glasses, bowls and
Crystal
lightly soiled pans.
A shorter wash for lightly
soiled loads that do not
Rapid
need drying.
To rinse dishes that you
plan to wash later that day
Pre-Rinse
EN 50242: this program is the test cycle
The information for comparability test in accordance with EN50242,as follows:
-
Capacity: 14 settings
-
Position of upper basket: Low position
-
Rinse aid setting:6 (or 4 for four setting dispenser)
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
14
Energy
Description
Detergent
Running
(kWh)
of Cycle
Pre/main
Time
(min)
Pre-wash
Main wash(60℃)
Rinse1
5/32.5g
213
1.500
Rinse2
(or 3 in 1)
Hot rinse
Drying
Pre-wash
Main wash(48 ℃ )
5/30
223
0.825
Hot rinse
(Or 3in1)
Pre-wash
Main wash(45℃)
5/20g
Rinse
152
0.950
(or 3 in 1)
Hot rinse
Drying
Main wash (40 ℃ )
Rinse
5/20g
124
0.900
Hot rinse
Drying
Main wash(45℃)
15g
40
0.550
Hot rinse
Pre-wash
12
0.010
2. Insert the plug into the socket. The power supply is 220V-240V AC 50HZ, the specification of the
socket is 12 A 220V-240V AC 50HZ.
Make sure that the water supply is turned on to full pressure. Open the door, press the ON/OFF
button, Press the "program." button to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table") . With a little force to ensure the door is properly closed.
Water
NOTE:
A click can be heard when the door is closed correctly.
(L)
When the washing is over, you can switch off the dishwasher by pressing the "Power" button
Changing the Programme.
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
18.0
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Filling the Detergent " ).
Open the door, Press current prog. button more than three seconds to cancel the programme, then
you can change the programme to the desired cycle setting (see the section entitled "Starting a wash
10
cycle. . . " ). Then, close the door.
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display
appears E1. When you close the door, the machine will resume.
The 6 programme lights show the state of the dishwasher:
a) All programme lights off --> stand by
14.0
b) One of the programme lights on --> cycle running
c) One of the programme lights blinking --> pause
NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling Customer Service.
11.0
Adding additional items during operation
Items can be added any time before the detergent cup opens.
7.0
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
4 Close the door, the dishwasher will resume after ten seconds.
4.0
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "---", only in this case the programme has ended.
Switch off the dishwasher by pressing the ON/OFF button.
Open the door carefully. Hot steam may escape when the door is opened!
■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
a few minutes before removing from the appliance.
■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
15