- ページ 14

アンプ Hifonics XX-Colossus IIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Hifonics XX-Colossus II 16 ページ。 Generation xx

2-Channel Bass Amplifier - Speaker wiring and Connections

Mono Subwoofer bridged

SUBSONIC- The variable Subsonic Filter is fully adjustable from 10Hz to 150Hz.

LOW PASS- The built-in low pass frequencies are fully adjustable from 40Hz to 4kHz.

BASS BOOST- The bass boost is fully adjustable from 0dB up to 18dB.

Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.

BASS EQ - In the LP\BP mode, you can control the bass equalization from 30Hz to 60Hz.

PHASE SHIFT - The Phase Shift is fully adjustable from 0 to 180 degrees.

LEVEL-

• Turn the INPUT LEVEL control on the amplifier to 9V position.

• Turn the head unit volume control to about 80-90% of its full setting.

• Turn the INPUT LEVEL control clockwise until you hear some distortion.

• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.

Connect RCA cable

From Head-unit with

RCA input (LINE INPUT).

HIFONICS

POWER

PROTECT

0dB

18dB

XXR-1

Remote Control -

Connection for remote

control. Allows you to

adjust the subwoofer

from your seat

XX-COLOSSUS II

Interconnect cable checklist:

• Connect the LINE INPUT of the amplifier to the head unit line output with good quality RCA

to RCA cables.

• Connect the speakers with the terminal block (SPEAKER OUTPUT/ - MONO +) of the

amplifier.

•The minimum final speaker impedance must not be below 2 Ohm per channel. Too low

speaker loads result in too high heat dissipation and may cause the amplifier run into

protection.

• Please observe speaker channel and polarity as printed by the speaker terminal

block.Incorrect phasing of the speakers results in total loss of bass response.

Be careful not to connect speaker (-) to the ground or vehicle chassis.

Caution!

Subwoofer 2 - 8 Ohm