- ページ 11

電動工具 909 PS120のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。909 PS120 15 ページ。 120w 200mm wetstone sharpener

ページを印刷する

Move the wheel around so the gauge touches the back of

the blade to be sharpened. The angled face of the gauge

should match the back face of the blade. Slide the blade

in or out of the tool holder to obtain a perfect alignment to

the gauge.

When the back of the blade aligns with the gauge, tighten

the adjustable clamp knobs sufficiently to prevent the

blade sliding.

Remove the gauge and check as above the blade is

evenly touching the sharpening wheel across the full

width of the blade.

Tighten the two adjustable clamp knobs.

Sharpening

Using the knife/blade sharpening holder

Your 909 PS120 sharpener

is supplied with a small knife

sharpener holder. This is suitable

for assisting in the sharpening of

small knives and blades.

It takes some time and practice

to master this operation, as it

is partly supported but also has

some free hand components,

where the blade may be curved.

Fitting the knife

to the knife holder

Loosen the two knurled screws

of the knife holder clamp

sufficiently, to slide the knife

between the holder and the top

clamp. The rear screw should

NOT be touching the lower

section of the knife holder

Fit the blade or knife into the holder and tighten the front

knurled screw while holding the top clamp late down flat on

the blade.

Note.

Do NOT use any tools to tighten these knurled screws.

The front clamp screw should now be holding the knife

or blade.

Tighten the second (rear knurled screw) to ensure the blade

is firmly clamped for sharpening.

Fit the tool support bar into the sharpening position as

previously described, but the tool support will also need to be

adjusted height wise to obtain the correct sharpening angle.

The knife holder also has an adjustable resting heel which

can also be adjusted up and down to obtain the correct

angle. Set the correct angle for the blade to be sharpened.

Using the adjustable tool holder

Tool sharpening is performed

by working against the direction

of rotation, with the tool support

located on top of the machine.

Note.

Ensure safety glasses are

worn during the sharpening and

honing process.

Note.

Ensure the water tray is filled with water, and the tray

is correctly fitted prior to starting the sharpening process.

Note.

During the sharpening process, frequently check the

water level in the reservoir and constantly top it up.

CAUTION.

Do not run the water reservoir dry or attempt to

sharpen dry, it may be dangerous to do so.

Note.

Before each operation check whether the surface of

the sharpening stone is even. If required, dress the stone as

described in the maintenance section of this manual.

1. Mount the tool into the tool

holder (9) and fit it to the tool

support bar (7) (refer to the

"Preparing for sharpening

section"

of this manual).

2. Select and set the sharpening

angle (refer to the

"Using the

angle gauge"

section is this

manual).