- ページ 16

ソウ 909 909210TSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。909 909210TS 18 ページ。 1200w 210mm 8" table saw

3. Press the work piece firmly against the mitre gauge.

4. Switch ON the saw.

5. Push the mitre gauge and the work piece toward the

saw blade in order to make the cut.

IMPORTANT.

Always hold the guided part of the work

piece. Never hold that part of the work piece, which is

being cut off.

Always push the mitre gauge far enough forward for the

work piece to be cut through completely.

Switch off the saw again. Wait for the saw blade to stop

before you remove the off-cuts.

Replacing the saw blade

CAUTION.

Switch off the machine and remove the

mains power plug before carrying out any adjustments,

maintenance work or blade changes.

1. Turn the blade depth adjustment wheel (10) until the saw

blade is at the maximum cutting depth.

2. Remove the 4 screws from the side panel.

3. Remove the 4 screws from

the blade cover side panel,

and angle the pin from the

track. Put to one side.

4. Use a small 8mm

open-ended spanner to

hold the spindle fast.

5. Use a second 19mm

spanner to undo the blade

nut by turning in an anti-

clock-wise direction (right

hand thread).

6. Remove the nut and outer flange and then take the blade

from the shaft.

7. Carefully clean the saw blade flange before you fit the

new or re-sharpened saw blade.

8. Insert and secure the saw blade in reverse order.