ページを印刷する
Components
The BS9 band saw is supplied
with the following components:
a. Band saw
b. Band saw blade (fitted)
c. Work table
d. Table insert (fitted)
e. Rip fence
f. Mitre gauge
g. Push stick
h. Table bracket, washer and bolt
i. Bolts & star washers for attaching table (x4)
j. Screw & nut for hanging push stick
k. 3mm hex key
l. 10mm wrench
i
l
e
f
g
k
j
Assembly
a
The band saw is shipped partly disassembled and the work
table and rip fence need to be installed prior to use.
1. Place the work table on the table trunnion (10) by
threading the saw blade through the slot in the table.
b
2. Secure the work table to the table trunnion using the four
c
hex bolts and star washers (i).
CAUTION:
Make sure the screws are tightened securely to
ensure they do not loosen in use.
3. Place the table bracket (h) onto the front of the work
table. Place the washer over the hex screw and feed the
screw through the bottom of the table and into the table
bracket. Tighten the hex screw using the 10mm wrench.
d
h
4. Attach the rip fence to the table and secure it by pushing
down the rip fence locking handle (26).
8