- ページ 8
パワードライバー ADENDORFF MAC AFRIC SDRILC-005のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。ADENDORFF MAC AFRIC SDRILC-005 14 ページ。 Cordless brushless driver/hammer drill
ページを印刷する
2. Removing instrument
To remove the bit, hold the ring and turn the
sleeve counterclockwise (view backwards).
(Fig. 7)
Switch Action
CAUTION:
Before inserting the battery cartridge
into the tool, always check to see that the switch trigger actuates properly and returns to
the "OFF" position when released.
Do not operate the machine at a low speed for too long, or the inside machine may
be overheated
To start the tool, simply pull switch trigger.
Tool speed is increased by increasing
pressure on the switch trigger and further
pressure results in an increase in speed.
Release the switch trigger to switch off the
tool. (Fig. 8)
Reversing Switch Action
CAUTION:
Always check the direction of rotation before operation.
Use the reversing switch lever only after the tool comes to a complete stop. Changing
the direction of rotation before the tool stops may damage the tool. When not
operating the tool, always set the reversing switch lever to the neutral position
Never force to pull the switch trigger while the the reversing switch lever is set to the
center position.
Clockwise Rotation
Depress the reversing switch lever from side B to side A for clockwise rotation for drilling
and driving in screws (view forwards).
Counterclockwise Rotation
Depress the reversing switch lever from side A
to side B for counterclockwise rotation for
loosening or unscrewing screws. (Fig 9)
Speed change
To change the speed, first switch off the tool
and then slide the speed change lever to the
"2" side for high speed or "1" side for low
speed. Be sure that the speed change lever is
set to the correct position before operation. Use
the right speed for your job. (Fig.10)
CAUTION:
1.
Always set the speed change lever fully to the correct position. If you operate the tool
with the speed change lever positioned halfway between the "1" side and "2" side, the
tool may be damaged.
2.
Do not use the speed change lever while the tool is running. The tool may be damaged.
3.
If frequent protection actions of fender occur when using the tool at the high speed,
the motor will stop running, position the change lever to the "1" side for continuous
operation.
4.
If speed change lever cannot be switched due to the crash of the gear tooth, softly
press the switch trigger to run the motor and then change the speed.