- ページ 13

ステレオ・イコライザー dbx iEQ-15のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dbx iEQ-15 16 ページ。 Graphic eq
dbx iEQ-15 にも：仕様 (2 ページ), ユーザーマニュアル (20 ページ), 概要 (4 ページ)

iEQ

The iEQ Series Equalizers have balanced inputs and outputs that can be used with any balanced

or unbalanced line-level device.

To connect the equalizer to your sound system refer to the following steps:

• Turn off all equipment before making connections.

• Mount equalizer in a standard-width rack.

Install the EQs in a rack with the rack screws provided. It can be mounted above or below

anything that does not generate excessive heat. Ambient temperatures should not exceed

113° F (45°C) when equipment is in use. Although the unit's chassis is shielded against radio

frequency and electromagnetic interference, extremely high fields of RF and EMI should be

avoided.

• Make audio connections via XLR, 1/4" TRS jacks or Euroblock connectors according to applica-

tion needs. All three types of connectors for the inputs and outputs can be used for balanced

or unbalanced connections. The use of more than one connector at a time for the inputs could

unbalance balanced lines, cause phase cancellation, short a conductor to ground, or cause dam-

age to other equipment connected to the equalizer. More than one output may be used simul-

taneously as long as the combined parallel load is greater than 600Ω.

• Select the operating range with the boost/Cut range selection switch

Note: Be sure to reduce audio levels at the power amplifiers when changing the setting of this

switch as it may generate an audible transient.

• Apply power to the equalizer. Connect the AC power cord to the AC power receptacle on the

back of the equalizer. Route the AC power cord to a convenient power outlet away from audio

lines. The unit may be turned on and off from the rear panel power switch or a master equip-

ment power switch. Since the iEQ Series Equalizers consume a relatively small amount of power,

the units may be left on continuously.

Basic Connection

Basic Connection of the iEQ

Operation

iEQ User Manual