- ページ 10

レンジ Galaxy 790.6070 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Galaxy 790.6070 Series 14 ページ。

General Care & Cleaning

Surface

Elements

and Drip Bowls-

Surface elements can be unplugged and removed to make cleaning the drip pans

easier. The surface elements clean themselves when they are turned on. Food spilled on a hot element will burn off. Food spilled

on a cool element may be cleaned with a damp cloth--any

remaining soil will burn off the next time the element is used.

Be sure the range is cool

before removing elements or drip bowls.

Be careful not to bend terminal ends

when replacing elements after cleaning.

Hold

Down

Clip

(if equipped)

Allow

Element

ipport

to rest

_n drip pan

inside

rim.

Terminal

End

rminal

Plug

Main top

Lift-up rod

Never immerse a surface element in water.

To Remove the Surface Elements

and Drip Bowls

Lift the edge of the drip bowl across from the terminal end. Lift the surface

element and drip bowl together

just enough to clear the cooktop.

While holding the drip bowl and surface element, gently pull the terminal end

out from the terminal plug. If equipped, DO NOT remove the hold down clip from

the drip bowl.

To Clean Drip Bowls

Wash in hot, soapy water or in the dishwasher. Rinse and dry while still warm. Hard

to remove, burned on soil can be removed by soaking the drip bowls for about 20

minutes in a lightly diluted liquid cleanser or a solution of ammonia and water (1/

2 cup ammonia to 1 gallon of water). A nylon scrubber may be used after soaking.

DO NOT use abrasive cleaners or steel wool, as they will scratch the surface.

Always rinse with clean water and polish dry with a soft cloth.

To Replace Drip Bowls and Surface Elements

Slide the terminal end on the element through the opening in the drip bowl.

Align the element support to rest on the rim inside the drip bowl. If your drip

bowl is equipped with a hold down clip, align the element support opposite the

terminal end with the slot in the hold down clip, and snap into place.

After the element is positioned in the drip bowl, line up the terminal end with

the terminal plug as shown.

Hold the surface element and drip bowltogetheras

level as possible and firmly

push the terminal end into the terminal plug. Make sure element terminal is

seated properly into terminal plug. Make sure the surface element is level to

reduce the hazard of pans sliding off the element.

To Raise the Top for Cleaning

Grasp the sides and lift from the front. Lift-up rods will support the top in a

raised position. Only lift the top far enough to allow the support rods to snap

into place.

Clean underneath using a clean cloth and hot, soapy water.

To Iowerthe top, gently push back on each rod to release the notched support.

Hold the range top and slide the lift rods down into the range frame.

When lowering the lift-up

range top, grasp the sides with finger-tips

only. Be careful not to pinch fingers. DO

NOT drop or bend the range top when

raising or lowering. This could damage

the surface.

Cleaning

Oven Bottom

The bake element is designed to be gentlytilted up using your hand from the front

of the bake element. This will allow easier access to the oven bottom for cleaning.

Be careful not to raise the element more than 4 or 5 inches from the resting position.

._J

Baking

element

may be tilted about

4 or 5 inches

to clean oven bottom