- ページ 8

カー・アンプ Hifonics Titan TXi4408のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Hifonics Titan TXi4408 13 ページ。

TXi7508 A/B CLASS 1 CHANNEL AMPLIFIER APPLICATIONS

Basic application

These sub bass amplifiers can be used in any of the bi-amplification systems described in

this manual, replacing the 2 channel amplifiers as per the illustrations.

Interconnect cable checklist:

Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.

Connect the LINE OUT to the inputs of the system highs amplifier.

Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,

simplifying the hookup of multiple speakers

DESIGNATED

MONO OUTPUT

FROM HEAD UNIT

MINIMUM 1-Ohm LOAD

SUBS CAN BE 2-Ohms EACH

POWER INPUT

GND

REM +12V

FULL RANGE

STEREO LINE INPUT

Note: You can use the Radio/CD designated mono line output or a full range stereo line output.

For full range stereo line output, you will need an optional "Y-Adaptor" as shown.

Crossover frequency control checklist:

LOW PASS: 40Hz to 150Hz

SUBSONIC:15 Hz to 55 Hz

BASS EQ: 0 to +12dB

Level control checklist:

Refer to the section "Setting up systems after installation for best performance"

Minimum final loudspeaker impedance: 1-Ohm.

SPEAKER OUTPUT

FUSE

Y-ADAPTOR

NOT USED

MONO

SUBWOOFER

TO BATTERY + 12 Volts

VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND