- ページ 13

ドリル 909 12V2BLIのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。909 12V2BLI 20 ページ。 12v lithium drill driver

ページを印刷する

Battery charging

IMPORTANT.

Before attempting to charge the battery,

check the charger, the charger base and the battery

to ensure the charging equipment matches the battery

supplied. The components are all labelled with

component numbers.

IMPORTANT.

The battery will be fully charged after aprox

3-5 hours: remove it from the charger after this time.

Do not leave a battery charging for longer than 24 hours.

Note.

The battery pack will not charge if the battery cells are

hot. If the pack has been directly taken from the drill after

heavy or constant use, the cells will be hot.

Allow the cells to cool before fitting to the charger adaptor.

If a hot pack is placed on charge the charge process will be

delayed until the battery pack cools when then the charge

process will start automatically.

If the green light does not come

on and the red light is illuminated

on the adaptor, the cells are not

charging and

the cells require some time to

cool.

DO NOT force cool the pack.

1. To install the battery pack on

the charger adaptor, align the

battery pack with the charger

base and insert firmly into place.

Note:

If the battery pack is incorrectly orientated the battery

will not fully enter the base as depicted.

2. Plug the charger into the

charger base and plug in the

charger and switch on at the

power supply. The green LED

indicator located on the charger

base will indicate that the

battery is being charged.

The red light on the base indicates that there is power to

the charger base. This red light is a power indicator and

will glow whenever power is supplied to the base.

3. The battery charging time is approximately 3-5 hours.

When the green LED goes out leaving the red LED

glowing the charging cycle is complete.

4. Turn off the charger power supply from the mains and then

remove the battery pack from the charger base.

Both the battery pack and the charger may become warm

to touch. This is also normal and not an issue of concern.

Both the battery pack and charger are fitted with thermal

safety devices and they will shut down if the temperatures

become too high.

To obtain the best life for the battery

Never allow the drill to come to a complete stand still

before recharging. The battery should be placed on charge

whenever the battery is noticeably running down or the

drill no longer performs a task it previously performed. For

storage, charge between 50 and 75%. Avoid allowing lose

items like screws or nails etc. to be stored with battery

packs as these or similar items can short battery packs

and cause a fire or explosion.

Always unplug the charger when not in use and store in

a dry secure place.

Avoid charging or storing your battery in temperatures

below 0ºC and above 40ºC.