- ページ 3

防虫機器 Agrizap Rat ZapperのPDF 製品・安全マニュアルをオンラインで閲覧またはダウンロードできます。Agrizap Rat Zapper 10 ページ。
Agrizap Rat Zapper にも：クイック・スタート・マニュアル (2 ページ)

1. Q: I turn on my unit and press the "Check Button," but the "Check Light" doesn't go on. How

come?

A: The Check Button is intended to check whether a rodent has triggered the zapper. If a rodent has

NOT triggered the zapper, the Check Light should NOT go on.

2. Q: The bait is gone, but the Check Light doesn't go on. How come?

A: There may be gaps between the C-cell batteries which prevent the zapper from zapping. Open the

large battery door and rotate the C-cell batteries. Make sure you have a fresh 9 volt alkaline battery

installed in the zapper. Also, see FAQ #4.

3. Q: The bait is gone, and the light goes on, but there is no mouse or rat. How come?

A: The zapper is sensitive to moisture. Rain, dew, or condensation can trigger the zapper. Make sure

the zapper is dry. Moist bait can trigger the zapper. Shake the Electrocution Chamber so that the bait

is all the way at the back by the Kill Grill. If that doesn't help, check the 9 volt battery; it could be

low. Occasionally, a large cockroach can set off the zapper. If you suspect you have roaches, you may

want to place a roach trap near the zapper.

4. Q: How to I test the Rat Zapper?

A: Using a plastic handled screwdriver, put the shaft of the screwdriver against the upper inside front

edge of the unit and touch the tip of the probe on the metal pad which you see near the center of the

tube. A rather substantial spark and "zap" will occur indicating the Rat Zapper is operating properly.

5. Q: How do I clean the zapper?

A: Make sure the zapper is OFF and the batteries are removed when cleaning the zapper. Rats are

wary, but they are more likely to enter the zapper if it smells like a rodent. If you must clean the

zapper, flush the Chamber out with a garden hose. If that is not sufficient, you can use electronic

contact cleaner and/or a nylon bristle brush. Contact cleaner contains alcohol and is combustible,

so be sure to allow several minutes drying time before testing.

6. Q: Why does the alarm sound or why does the Check Light come on when I turn the zapper on?

A: Two main reasons for this: rodent urine or dead 9-volt battery. Usually rodent urine is not a

problem because it evaporates fairly quickly, but it can cause problems. See FAQ #4 on how to clean

the Rat Zapper. Also, you could have a 9-volt battery that is low. Try replacing it with one that is

known to be good.

7. Q: The zapper seems to zap, but I keep finding it triggered with the bait gone. Why?

A: Again, this could be due to moisture from condensation or high humidity, but there may be a more

gruesome cause. Rats and mice can be cannibalistic. When one gets zapped, it is possible that the

others are dragging the body away and stealing the bait. To test this theory, try sprinkling some flour

in front of the zapper to see if you can detect any dragging. Occasionally, a large cockroach can set off

the zapper and rats like eating those too!

8. Q: They won't take the bait. What should I do?

A: Rats are wary of new objects in their environment. We suggest that you place some bait in the

Electrocution Chamber and some bait out in front. If they don't even take the bait in front of the

Chamber for three days, try these suggestions:

Frequently Asked Questions (FAQ)

Updated August 7, 1998