- ページ 9

ドリル 909 KHD1050KのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。909 KHD1050K 12 ページ。 1050w rotary hammer drill

ページを印刷する

Rotation only mode of operation (as used for drilling in

wood or metal with the SDS chuck or the keyed chuck)

1. Set the rotary selection knob (5) to the position

2. Set the hammer action lever (11) to the right .

Rotary hammer mode of operation (as used for

hammer drilling with the SDS chuck only)

1. Set the rotary selection knob (5) to the position

2. Set the hammer action lever (11) to the left

Hammer only mode of operation (as used for chiseling

or chasing with the SDS chuck only)

1. Set the rotary selection knob (5) to the position .

2. Set the hammer action lever (11) to the left

Switching on and off

1. Connect the plug to the power

point.

2. Depress the trigger switch (1)

to start the drill and release

the trigger when you wish to

stop.

Inserting SDS bits

CAUTION.

plug is removed from the power point before making any

adjustments.

1. The drill features an SDS

Plus

easy and safe bit replacement.

Before inserting the bit always

ensure that the bit end being

inserted is clean and greased.

2. Slide back the locking sleeve

(10) and insert the SDS Plus

bit into the chuck opening.

3. To secure the bit release the locking sleeve.

Note.

The SDS Plus bit needs to be inserted in a specific

way to ensure it locks into the chuck. To check your attempt,

pull the bit out of the chuck and if it comes out, reinsert the

bit and spin the bit in order to locate it better.

4. To remove the bit, slide back the locking sleeve, remove

the bit, and release the locking sleeve.

Operation

1. Hold the drill with your two upper fingers comfortably on

the trigger switch.

2. Use the auxiliary handle (7) where possible to gain extra

control and to prevent fatigue.

Always ensure that the drill is switched off and

system which enables