- ページ 6

電源 AGRO ELECTRO DL 4500のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AGRO ELECTRO DL 4500 20 ページ。

ページを印刷する

Charge level indicator

• Flashing green — Maximum charge level.

• Continuous green — Normal charge level.

• Continuous orange — Low charge level.

• Continuous red — Very low charge level.

• Flashing red — Accumulator depleted.

Normally this light has to be continuously green.

When the color turns into orange or red, switch off the lights,

disconnect the consumers for a while to allow the efficient

recharge of the accumulator.

The electric fence energizer

The electric fence energizer generates short, high voltage electrical

pulses with a period of approximately one second. These pulses

are conducted into the wires of the electric fence. When an animal

touches the fence wire, the electrical circuit closes through the

ground. The suffered shock is not dangerous, but it has an extremely

unpleasant effect, the animals that touch the wires of the electric

fence, will learn very quickly to stay away.

The electric fence energizer has to be connected to the fence via the

blue cable. This cable has a special insulation, so it can touch the box,

the posts, trees, etc., it can even be touched with bare hands without

electrocution (of course the bare end of the cable is an exception).

This cable has to be connected (with a connector) to one of the wires

of the electric fence (since the rows of wires of the electric fence

must be bridged at distances of at least 100 meters, the high voltage

pulses will reach each row of wires). It is recommended to bridge the

fence wires right where the blue cable is connected.

Avoid altering the electrical connections while the energizer

device operates, especially with the blue cable left bare! If a high

voltage pulse touches a nearby electronic circuit, it destroys

instantly! This also applies to other electronic devices, such as

mobile phones, electronic watches, cameras, etc. – carefully

avoid bringing these devices close to the electric fence device,

the pulse output, or even to the wires of the electric fence!

LEDs on the device:

• Left – The device is under operation.

• Right – Normally off, it turns on in red if the supply voltage drops

below 10.5 V (discharged accumulator). This situation is also

indicated by the charge controller

switch off the device to allow the effective recharging of the accu-

mulator, or consider replacing it with a charged one).

Maintenance and inspection

Although the system may operate autonomously for months, or even

years, you will need regular inspection and maintenance to avoid

unpleasant surprises (such as escaped animals) due to a discharged

accumulator, or unwanted short circuits of the fence wires, caused

by vegetation.

Periodically clean the surface of the solar panel with a damp cloth!

Dust deposits, leaves, significantly reduce its efficiency, which can

cause rapid discharge of the accumulator.

Avoid discharging the accumulator at night or in mostly cloudy

weather by regularly monitoring the indicator lights

charge controller

. If the color of the LED

red, temporarily turn off the energizer device to allow recharging

the accumulator. Optionally, the accumulator can be replaced with

a spare one to prevent the interruption of the system.

Check the entire fence frequently and eliminate the growing vege-

tation that touches the wires. Short circuits caused by vegetation

significantly reduce the efficiency of the electric fence.

For an efficient operation of the electric fence, the voltage in the

wires must be at least 2000 V. Measuring the voltage is possible only

with a special measuring instrument (called an electric fence tester).

We strongly recommend to purchase such a tester. DO NOT use digital

or analog measuring devices, these will be destroyed instantly on

contact with the high voltage!

via the LED

(in this case,

and

on the

changes to orange or