- ページ 5

アンプ Galaxy Audio G-1200のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Galaxy Audio G-1200 16 ページ。 G-series amplifiers

Connection to main power supply

Before connecting the amplifier to a power socket, always make certain that:

1. The electric system and power socket have adequate grounding compatible with the safety

norms (if you are uncertain, consult specialized personnel);

2. The power supply voltage corresponds to that shown on the rear of the unit (an allowance of up

to +/-10% is accepted);

3. The power cord is not damaged and has no bare wires;

4. The on/off switch is in the off position.

Make sure the amplifier is also off before disconnecting the power cord from the main power

socket.

Switching on and off

In your sound reinforcement system, always switch on the amplifier after all the other equipment

and always switch it off before anything else, if possible with the gain controls set at minimum: this

will avoid annoying and sometimes dangerous signal peaks.

Installation and use

This amplifier generates high power, so install it in locations which ensure correct air circulation.

Avoid long exposure to direct sunlight, sources of strong heat, powerful vibrations, very dusty or

particularly damp surroundings or rain: this will prevent possible faulty operation, deterioration or

even electric shocks and fires. The air for cooling the unit is forced in through the vents in the front

panel and out through those on the rear panel, so make certain that there's sufficient space

around the amplifier to allow adequate air circulation.

If racks or flight-cases are used, make sure that airflow is unobstructed: do not install the amplifier

in racks or flight-cases with closed backs. Since part of the heat is dissipated via the metal bottom

of the amplifier, it's advisable to install the amplifier with at least one rack unit space between

them.

Audio connections

Remember to always connect and disconnect other units with the amplifier switched off. Always

use good quality cables of the appropriate type, described in the "connection cables" chapter of

this manual.

Take care of your connector cables, which are a frequent cause of problems. Check their condition

frequently. Always grip them by the connector, avoid pulling them forcefully and coil them without

forming knots or sharp bends: they'll last longer this way and be more reliable.

INSTRUCTIONS AND INSTALLATION

ATTENTION !!!

The G-SERIES amplifiers generate high voltage on output.

To avoid the risk of electric shocks. DO NOT TOUCH any bare

wires when the unit is switched on.

This manual contains important information for correct safe use,

read it carefully before using your amplifier.