- ページ 12

制御システム DynaQuip WaterCop WPRS095のPDF オーナーズマニュアルとインストレーションマニュアルをオンラインで閲覧またはダウンロードできます。DynaQuip WaterCop WPRS095 16 ページ。

The transmitter in the wireless sensors and the receiver in the Water Control Panel communicate

by radio frequency . The smaller the distance between them, the stronger the signal will be .

Transmission distance is somewhat dependent upon the building layout and the type of

construction . The transmitter (the box attached to the sensor probe) must be kept dry . It is NOT

splash proof . Sensors should never be placed outdoors . The sensor probe detects the water

from a leak and is completely waterproof . Sensor probes should be placed on the surface or

in areas where water would tend to accumulate rapidly in common leak or overflow situations .

Make sure that any water from a leak will drain toward the sensor probe, not away from it.

Avoid high traffic areas where the cord or sensor probe could be stepped on or kicked and

where children or pets may disturb it . The sensor probe should be placed FLAT on the surface

so water can be detected as soon as it begins to accumulate. The sensor probe should be

secured to the surface with screws or adhesive . To avoid damage to transmitters and to provide

for the strongest signal possible, the transmitter portion of the leak sensor should be mounted

in a convenient location (on the wall, in a cabinet, closet, etc . ) 2 to 3 feet above the floor . (See

Installation section for details on sensor installation . )

WaterCop® Range Enhancing Repeater

Secure mounting tab

and screw

Why a Repeater?

If any of your WaterCop® wireless sensors are unable to communicate directly with your

WaterCop® Pro Control Panel during initial set-up and testing, adding a repeater (or more) to your

system may be the solution .

Basic Operation

Upon initial power-up, the red and green LEDs will flash and then go out . The LEDs light up when

the device is receiving and transmitting signals from WaterCop® wireless sensors .

Proper Location

Identify an unused 110VAC wall outlet/receptacle roughly midway between the WaterCop® Pro

Control Panel and the WaterCop® sensor that is farthest away and plug in the repeater . Test the

sensor(s) to ensure they now close the valve from the farthest location . Sometime more than one

repeater may be necessary due to great distances, obstructions, or type of construction .

High quality AAA alkaline batteries from brands like Energizer® and/or Duracell® are

recommended for powering your WaterCop® Classic sensors . It is recommended that you

replace the batteries in your WaterCop® sensors at least every 4 years . To ensure optimal

performance of your WaterCop® system, we recommend an immediate change of the batteries

in any sensor that has detected a water leak . Each wireless sensor will communicate a low

Red Transmit LED

Green Receive LED