メディア・コンバーター Autonics BD-CRSのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Autonics BD-CRS 3 ページ。 Laser displacement sensor communication converter
ページを印刷する
DRW190526AE
Laser Displacement Sensor
Communication Converter
BD-C Series
For your safety, read and follow the considerations written in the instruction
manual, other manuals and Autonics website.
The specifications, dimensions, etc are subject to change without notice for product
improvement Some models may be discontinued without notice.
Features
• Supports both RS232C and RS485 communication in one device
: Separate ports for RS232C and RS485
• Connect up to 8 amplifier units
• Can be powered directly by amplifier units without additional wiring
• Support for dedicated device management software (atDisplacement)
: Batch parameter settings with save/load function
: Monitor measured values and outputs in real-time
• Set communication speed and addresses using DIP switch without connecting to host
devices
ᜢ ᜧ ᜣ ᜫ
Safety Considerations
• Observe all 'Safety Considerations' for safe and proper operation to avoid hazards.
• symbol indicates caution due to special circumstances in which hazards may occur.
Warning
Failure to follow instructions may result in serious injury or death
01. Fail-safe device must be installed when using the unit with machinery that
may cause serious injury or substantial economic loss.(e.g. nuclear power
control, medical equipment, ships, vehicles, railways, aircraft, combustion
apparatus, safety equipment, crime/disaster prevention devices, etc.)
Failure to follow this instruction may result in personal injury, economic loss or fire.
02. Do not use the unit in the place where flammable/explosive/corrosive gas,
high humidity, direct sunlight, radiant heat, vibration, impact or salinity
may be present.
Failure to follow this instruction may result in explosion or fire.
03. Do not disassemble or modify the unit.
Failure to follow this instruction may result in fire.
04. Do not connect, repair, or inspect the unit while connected to a power
source.
Failure to follow this instruction may result in fire.
05. Check 'Connections' before wiring.
Failure to follow this instruction may result in fire.
Caution
Failure to follow instructions may result in injury or product damage
01. Use the unit within the rated specifications.
Failure to follow this instruction may result in fire or product damage.
02. Use a dry cloth to clean the unit, and do not use water or organic solvent.
Failure to follow this instruction may result in fire.
Cautions during Use
• Follow instructions in 'Cautions during Use'. Otherwise, it may cause unexpected
accidents.
• Do not install where strong magnetic or electric field exist. Otherwise, the resolution
may be adversely affected.
• Wire as short as possible and keep away from high voltage lines or power lines, to
prevent surge and inductive noise.
• For the optimized performance, it is recommended to measure after 30 minute from
supplying power.
• When detecting with the maximum sensitivity, an error may occur depending on each
characteristic deviation.
• This unit may be used in the following environments.
- Indoors (in the environment condition rated in 'Specifications')
- Altitude max. 2,000 m
- Pollution degree 2
- Installation category II