- ページ 2

医療機器 dynarex 10462のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dynarex 10462 2 ページ。 Half length bed rail

MOUNTING INSTRUCTIONS

1. Attach the bed rail to the frame of the moving head

deck. DO NOT attach to the fixed bed frame.

2. While holding the rail on an angle, slide the rail so

that the bottom edge of the bed frame sits inside the

fixed clamp jaw.

3. Slide the movable clamp jaw over the top of the

frame. Ensure that the movable clamp jaw at the top

of the mechanism attaches to the top edge of the bed

frame, and the bed frame sits between the clamp

jaws. (Figure 1)

FIGURE 1

KNOB

FIXED CLAMP JAW

4. Tighten knob to secure it into place.

MOVABLE CLAMP JAW

BED FRAME RAIL

RAIL OPERATION

To Raise Bed Rail: Pull out retainer bar, raise rail to

highest position, and release retainer bar, ensuring that

rail is securely trapped by retainer hooks.

To Lower Bed Rail: Raise rail slightly to release retainer

hooks, pull out retainer bar, lower rail and release

retainer bar.

WARNING

Read instructions carefully before installing.

Before use, ensure that the Bed Rail is assembled and

installed as described, that all attaching hardware is

securely tightened, and that the Bed Rail is securely in

place; inspect frequently to ensure that all attaching

hardware is securely tightened, and that the Bed Rail is

securely in place.

DO NOT place two bed rails on the same side of

the bed.

When installing bed rail, only place one rail on bed

per side.

Incorrect mounting may cause injury or death.

DO NOT use the Bed Rail as a handle for getting into or

out of bed; this could result in personal injury and

damage to the Bed Rail.

DO NOT exert side pressure on the Bed Rail; this could

deform or break it.

DO NOT use the Bed Rail as a push handle for moving

the bed; this could deform or break it.