- ページ 6

ミュージックペダル DC Pedals 5-Channel Bluetooth LooperのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DC Pedals 5-Channel Bluetooth Looper 12 ページ。

5-Channel Bluetooth Looper

– User Manual

Bank and Folder will be set automatically according to the received preset number. The looper will

automatically be set to Preset Mode after receiving a MIDI PC message.

MIDI Control Change Messages:

The Looper will respond to MIDI CC

messages sent on the MIDI Input Channel.

The Loops and TRS functions can be

controlled as well as remote saving of a

preset. See the table below for the CC IDs

and responses.

Response to MIDI CC

messages can be turned off via the MIDI CC

Receive configuration parameter in the

Looper configuration pages.

See the

Configuration

section

for

information.

Looper Mute:

The mute feature is OFF after the Factory

Reset.

If there are significant pops or

noises while switching loops, activate the

Mute feature to reduce the noises.

However, some audio signal is lost when

the Mute is ON. The short mute time is

about 7ms and the long time is about

24ms.

Choose the shortest time that

reduces the noises.

Looper Configuration:

There are many configuration options to configure the Looper for your needs. The configuration pages are

accessed during power-up. To access the configuration pages, hold the Mode switch during power-up. The

Mode LED will toggle while the switch is held. Release the switch and the Looper will enter Configuration

Mode. While in Configuration Mode, the Mode LED indicates the active configuration page. There are five

configuration pages. Press the Mode switch to cycle through the five configuration pages.

Page 6 of 12