- ページ 6

I/Oシステム Autonics ADIO-PNのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Autonics ADIO-PN 10 ページ。 Remote i/o boxes (profinet)
Autonics ADIO-PN にも：製品マニュアル (10 ページ)

ページを印刷する

Device Name Settings

To connect to the PROFINET network, configure the PROFINET interface. The PROFINET device name can be configured using the following methods.

■ Rotary switches

᜸

Be sure to place the seal of the protective cover 昀椀rmly on the rotary switches after completing the settings.

The protection rating is not guaranteed when the protective cover is open.

x100

x10

01. Rotate the rotary switches to set the device name. The green LED of the US indicator 昀氀ashes.

Setting mode

Rotary switches

000

PROFINET Device Name

001 to 999

02. Turn on the ADIO-PN again.

03. Check that green LED of the US indicator is ON.

04. The device name has been changed.

05. Put the protective cover on the rotary switches.

■ atIOLink

The PROFINET device name con昀椀gured by the atIOLink software is stored in the ADIO-PN's EEPROM. For more information, refer to the atIOLink User Manual.

Description

This device name is stored in the ADIO-PN's EEPROM.

Applying the device name con昀椀gured on the PROFINET Master or DCP tools.

Establish the communication connection after setting the ADIO-PN's device name.

The value of rotary switches is displayed at the last of the device name.

Value

PROFINET device name

ADIO-PN-MA08A-ILM-□□□