- ページ 12

血圧モニター iHealth ABP100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。iHealth ABP100 16 ページ。 Ambulatory blood pressure monitor

CARE AND MAINTENANCE

Strictly in accordance with product instructions to maintain and clean the device.

If this monitor is stored near freezing temperatures, allow it to return to room temperature before use.

If the monitor is not used for a long time, please be sure to fully charge it every month.

No monitor component needs to be maintained by the user. The circuit diagrams, component part lists,

descriptions, calibration instructions, or other information which will assist the user's appropriately qualified

technical personnel to repair those parts of the equipment which are designated for repair can be supplied.

Clean the monitor with a dry, soft cloth or a moistened and well wrung soft cloth using water, diluted disinfectant

alcohol, or diluted detergent.

The monitor can maintain the safety and performance characteristics for a minimum of 30,000measurements or

three years of usage, and the cuff integrity is maintained after 1,000 open-close cycles.

The battery can maintain the performance characteristics for a minimum of 300 charge cycles.

It is recommended that if the cuff is used in a hospital or a clinic, it be disinfected twice a week. Wipe the inner

side (the side that contacts skin) of the cuff with a soft cloth lightly moistened with Ethyl alcohol (75-90%). Then

air dry the cuff.

It is recommended that product performance be checked every 2 years or after each repair. Please contact the

customer service.

Do not use the device if you think it is damaged or if anything appears unusual. Please refer your device to

qualified service personnel of the manufacturers.

The monitor requires 6 hours to warm or cool from the minimum storage temperature between uses until the

monitor is ready for its INTENDED USE when the ambient temperature is 20 °C.

It may lead to inaccurate results or equipment failure if the device is stored or used outside the specified

temperature and humidity ranges.

Do not drop this monitor or subject it to strong impact.

Avoid high temperature and direct sunlight. Do not immerse the monitor in water as this will result in damage to the

monitor.

Do not attempt to disassemble this monitor.

Battery replacement should only be performed by a qualified iHealth technician. To do otherwise will void your

warranty and possibly damage your unit.

Cuff replacement should only be performed by a qualified iHealth technician. To do otherwise

will possibly damage your unit.

The iHealth CardioMed Blood Pressure Monitor is warranted to be free from defects in materials and workmanship

within one year from the date of purchase when used in accordance with the provided instructions. The warranty

extends only to the end user. We will, at our option, repair or replace without charge the iHealth Next Blood Pressure

Monitor covered by the warranty. Repair or replacement is our only responsibility and your only remedy under the

warranty.

Symbol for "DEFIBRILLATION-PROOF TYPE BF APPLIED PARTS" (cuff only)

for about 10seconds to reset the

device.

12 / 16