- ページ 3

呼吸器製品 dynarex Resp-O2のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dynarex Resp-O2 6 ページ。 Compressor nebulizer
dynarex Resp-O2 にも：取扱説明書 (2 ページ), 取扱説明書 (2 ページ), 取扱説明書 (2 ページ), 取扱説明書 (2 ページ)

ページを印刷する

OPERATING INSTRUCTIONS

1. Connect either end of the 6" silicone tubing to the top of

Suction Canister connector, then connect the other end

to the bacteria filter. Use the other 6" silicone tube to

connect the bacteria filter to the Suction Unit (Figure 6).

2. The patient tubing connects to Suction Canister (Figure 1).

3. Make sure the power switch located on the side of the

unit is in the "Off" position before connecting the unit to a

power source (Figure 2).

Fuse

4. Turn the power switch to the "I" position, to start the device

(Figure 3).

5. Adjust the suction level from 0 to 560 mmHg by turning

the vacuum adjustment knob clockwise to increase

and counterclockwise to decrease (Figure 4). It is

recommended to test the pressure before using the

device on a patient. Simply block the end of the patient

hose or block the Suction Canister lid intake and allow

the gauge to reach a stable vacuum reading.

Vacuum Gauge

Vacuum Adjust Knob

Power switch

"Off" position

Figure 2

Power switch

"On" position

Figure 3

Figure 4

6. It is recommended to test the connections for any leaks

prior to being used on a patient.

7. Place the tubing to the appropriate location and start to

gently suction.

8. When the Suction Canister reaches a safe, full level

(800 cc), the suctioning will stop automatically. The

float shut-off, located under the lid, will activate to avoid

over-filling (Figure 5).

Suction Canister

9. Turn the power switch to "O" position to turn off the

suction motor.

10. Remove the lid and dispose the waste liquid from

Suction Canister.

CAUTION:

1. When the automatic float shut-off is activated,

contents in the Suction Canisters should be

disposed of. Further suctioning could cause

damage to the vacuum pump.

2. Should fluid be aspirated back into the unit, call an

authorized service technician to inspect the vacuum

pump as it may have been damaged.

Suction Unit • Vacuum Levels up to 560 mmHg (Reorder No. 32300-32301)

Figure 5

Safe

Full

Level