- ページ 2
フィットネス機器 dynarex 10502のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。dynarex 10502 2 ページ。 Pedal exerciser
ページを印刷する
ASSEMBLY INSTRUCTIONS
FOOTREST PAD
SWIVEL SHAFT
RING
COUNTER
1. Remove contents from box.
2. Pull legs in opposite direction until locking button
"snaps" into locking receiver (see figure A). To
close, pull locking ring and bend leg down.
Repeat on other leg (see figure B).
3. Tighten tension knob on top of Pedal Exerciser
and turn clockwise to tighten. The tension knob
will increase/decrease the amount of tension on
the Pedal Exerciser. Tighten/loosen to a level
that feels comfortable.
figure A
figure B
TENSION KNOB
FOOTREST PLATE
PLASTIC COVER
HINGE
CONNECTING TUBE
TUBE
PAD
AUTOMATIC OPERATION
1. MODE (red button): This control allows you to
select a particular function. To start, press and
hold the red button for 4 seconds. The LED will
display the different functions. (If after turning on
and there is no activity, the unit will
automatically shut off).
2. To select a function, wait until the 4 second set
up is complete. Push the red button and the
arrow will move through the functions. When the
desired function is selected, simply use the
Pedal Exerciser and the unit will calculate the
exercise.
3. TIME: Determines the amount of time the Pedal
Exerciser has been operating.
4. COUNT (CNT): Determines the amount of steps
while operating the Pedal Exerciser.
5. CALORIE (CAL): Determines the amount of
calories burned while using the Pedal Exerciser.
6. REPS PER MINUTE (R.P.M.): Automatically
calculates the repetitions per minute.
7. SCAN: Will automatically review the results of all
functions.
BATTERY REPLACEMENT
If the display does not come on or reads
incorrectly, the battery requires replacement.
To replace the battery, use a small screwdriver and
remove the display panel. Turn the display panel
over and remove the watch-style battery. Insert a
new battery and replace the display panel.
WARNING: Device may become hot with
extended use.