- ページ 3

ツール DCA Z1G-FF-15のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DCA Z1G-FF-15 7 ページ。 Percussion hammer

20. Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edges are less likely to bind and are
easier to control.
21. Check for misalignment or binding of moving parts, breakage of parts,
and any other condition that may affect the tools operation. If damaged,
have the tool serviced before using. Many accidents are caused by poorly
maintained tools.
22. Use only accessories that are recommended by the manufacturer for
your model. Accessories that may be suitable for one tool, may become
hazardous when used on another tool.
Service
23. Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
24. When servicing a tool, use only identical replacement parts. Follow
instructions in the Maintenance section of this manual.
unauthorized parts or failure to follow Maintenance instructions may create a
risk of electric shock or injury.
VOLTAGE WARNING:
Before connecting the tool to a power source (receptacle, outlet, etc.), be sure the
voltage supplied is the same as that specified on the nameplate of the tool. A
power source with voltage greater than that specified for the tool can result in
SERIOUS INJURY to the user, as well as damage to the tool. If in doubt, DO NOT
PLUG IN THE TOOL. Using a power source with voltage less than nameplate
rating is harmful to the motor.
Use of
-3-

SPECIFICATIONS

Rated Power Input
Blows per Minute
Net Weight
※Due to the continuing program of research and development, the specifications
herein are subject to change without prior notice.

ADDITIONAL SAFETY RULES

1. Be sure to wear a safety helmet. Also wear ear protectors, safety glasses, face
shield and/or thickly padded gloves when necessary.
2. Check and ensure that the bit be correctly installed and secured before operation.
3. Hold tools by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock the operator.
4. Vibration will be occurred in normal operation according to the design. That will
cause the screws easy to be loosened and invite damages and accidents. Check
tightness of screws carefully before operation.
5. In cold weather or when the tool has not been used for a long time, let the tool
warm up for a while by operating it under no load. This will loosen up lubrication.
Without proper warm-up, hammering operation is difficult.
6. Always be sure to have a firm footing. Use safety belt and be sure no one is below
when using the tool in high locations.
7. Always use the auxiliary handle and hold the tool firmly with both hands.
8. Keep hands away from the rotating parts.
9. Do not leave the tool running. Operate the tool only when hand-held.
10. Do not point the tool at anyone in the area when operating. The bit could fly out and
injure someone seriously.
1240 W
1400 .../min
16 kg
-4-