- ページ 6

自動車アクセサリー High Lifter MCFFA-C1DのPDF マニュアルをオンラインで閲覧またはダウンロードできます。High Lifter MCFFA-C1D 9 ページ。 Max clearance can-am defender front forward arched control arm kit

ページを印刷する

10. Before you install the new control arms you need to install the four steering stops. There are two per

side.

11. Turn the steering wheel OPPOSITE the side you are working on. If you are working on the passenger

side turn it all the way to the left.

NOTE: In order to re-secure the boot, you will need to turn the steering wheel closer to the center

to give you some play in the boot.

12. The boots on the rack and pinion are held on by zip ties. You will need to cut the zip tie that secures the

boots to the inside of the rack and pinion. Next pull the boot back to expose the inner tie rod joint.

13. Place the steering stop clips (2ea) between the inner tie rod joint and the rack and pinion. It is a tight fit,

so you may have to force it on this is to ensure that the spacer stays in place.

NOTE: We used two per side because one large steering stop was too difficult to install!

14. Pull boot back over the ball joint and steering stop and refasten with 11" zip tie. Be sure to verify the

zip tie is tight so prevent material from getting into the boot.