- ページ 3

ヒーター iHeater mini 500 IH-101のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。iHeater mini 500 IH-101 8 ページ。 Infrared heater

ページを印刷する

IMpOrtant InstructIOns

WarnInG! - WHen usInG eLectrIcaL appLIances, basIc precautIOns sHOuLd aLWays be FOLLOWed

tO reduce rIsK OF FIre, eLectrIcaL sHOcK, and Injury tO persOns, IncLudInG tHe FOLLOWInG

1. Read all instructions before using this appliance.

2. When heater is in use, keep away from air output grill

to avoid burns. Keep unit at least 3 feet away from

combustable materials such as furniture, pillows,

bedding, paper, clothing and curtains.

3. Extreme caution should be taken when using any

appliance around children, elderly, or disabled persons;

or whenever the heater is operating unattended.

4. Always unplug the heater when not in use.

5. Do not use outdoors.

6. This heater is not intended for use near water. Never

locate appliance where it may fall into a bathtub or

other water container.

7. To disconnect the appliance, turn controls to off, then

remove the plug from the outlet.

8. Connect to properly grounded outlets only.

9 . Do not insert or allow foreign objects to enter any

ventilation opening as this may cause an electric shock,

fire, or damage to the appliance.

10. To prevent a possible fire, do not block air intakes

or exhaust in any manner. Do not use on soft surfaces

like a bed, where openings may become blocked.

11. Do not use in areas where gasoline, paint,

or flammable liquids are used or stored.

12. Use this appliance only as described in this manual.

Any use not recommended by the manufacturer may

cause fire, electric shock, or injury to persons.

13. To prevent an overload and blown fuses, be sure that

no other appliance is plugged into the same outlet

(receptacle) or into another outlet (receptacle) wired into

the same circuit. (See exception for iHeater Mini point #20)

14. It is normal for the heater's plug and cord to feel warm to

the touch. A plug or cord which becomes hot to the touch

or becomes distorted in shape may be a result of a worn

electrical outlet (receptacle). Worn outlets or receptacles

should be replaced prior to use of the heater. Plugging

this heater into a worn outlet (receptacle) may result in

overheating of the power cord or fire.

15. Be sure that the plug is fully inserted into an appropriate

receptacle. Please remember that receptacles also

deteriorate due to aging and continuous use; check

This heater is to be used on a 120-volt circuit. The cord has a 3-prong plug as shown and

should only be plugged into a 3-prong, 120-volt grounded wall outlet. (Figure 1). If your wall

outlet is older and does not have a 3-prong socket, you should use a grounding adapter

which must be connected to a permanent ground. (As seen in Figure 2).

save tHese InstructIOns

Grounding Instruction:

periodically for signs of overheating or deformations

of the plug. If any overheating or deformations are

present, immediately discontinue using the receptacle

and contact a qualified electrician.

16. Caution: to prevent electric shock, match wide blade

of plug to wide slot of receptacle and insert completely.

17. Do not cover the appliance while it is functioning in order

to avoid overheating or risk of fire.

18. Do not place the heater near a bed because objects such

as pillows or blankets can fall off the bed and be ignited

by the heater.

19. Always plug heaters directly into a wall outlet/receptacle.

Never use with an extension cord or power strip, except

when using the iHeater Mini docking station.

20. The iHeater Mini contains an external outlet with a 500

watt maximum to use for items such as a lamp. Do not

use for items that require more than 500 watts such as

a vacuum cleaner.

21. Do not operate heater with a damaged cord or plug,

after the heater has malfunctioned, or if the heater has

been dropped or damaged in any manner. Discard heater

or return to an authorized service facility for examination

and/or repair.

22. Do not run the cord under carpeting. Do not cover

cord with throw rugs, runners, or similar coverings.

Do not route cord under furniture or appliances.

Arrange cord away from traffic areas and where it

will not be tripped over.

23. Check your heater cord and plug connections.

a) Faulty wall outlet connections or loose plugs can cause

the outlet or plug to overheat. Be sure the plug fits

tight into the outlet.

b) Heaters draw more current than small appliances.

Overheating of the outlet may occur even if it has

not occurred with the use of other appliances.

c) During use, check frequently to determine if your plug,

outlet, or faceplate is hot. If it is, discontinue use of the

heater and have a qualified electrician check and/or re-

place faulty outlets.

24. Do not block air intake or place unit behind drapes

or behind furniture.

(Correct Wall Receptacle)

3-Prong

iHeater Cord

GROUNDING

Figure 2

Figure 1

(Grounded Adapter)

METAL SCREW

COVER OF GROUNDED

OUTLET BOX