- ページ 6
双方向ラジオ Dynascan PMR446のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dynascan PMR446 11 ページ。 Handheld transceiver
Dynascan PMR446 にも: 取扱説明書 (16 ページ), 取扱説明書 (10 ページ)
4. OPTIONAL ACCESSORIES:
Consult with your reseller or distributor for information on the accessories available for this PMR446 two-way radio.
5. GETTING STARTED:
i.
INSTALLING/REMOVING THE BATTERY PACK:
The battery pack is located at the rear of the radio. To install it, simply insert
the battery pack into the bottom of the radio and press on the top until it is
securely fixed with the latch. To remove the battery pack, slide down the latch
from the battery pack and remove it from the radio.
ii.
CHARGING THE BATTERY:
Insert the battery pack or the radio with the battery pack attached into the
charging station. Insert the output terminal of the AC/DC adaptor into the DC
jack of the desktop charger and insert the AC/DC adaptor into a nearby and
easily accessible 230 VAC wall outlet. The disconnection device is the AC/DC
adaptor. You can also charge the battery pack by connecting the cable from
the AC/DC adaptor directly into the side connection of the battery pack.
Note:
-
When the battery pack charging is performed with the battery installed into the radio, ensure that the
radio is turned OFF.
Note:
-
Do not use any type of glue to fix the belt clip, as this can damage the battery case.
v.
FITTING THE LANYARD:
Use the hole at the top of the radio to secure the neck strap.
iii. FITTING THE HEADSET (OPTIONAL):
Connect the headset cable into the connector on the side of the radio.
iv. FITTING THE BELT CLIP:
Place the belt clip on the back of the battery pack and secure it with the screws
supplied.
6