ページを印刷する
3. push ENTER;
4. turn the Encoder knob to select AUTO, MANUAL
5. press ENTER
6. press the VFO/MR knob to exit
TOT setting
To prevent continuous emission of the radio, the unit can be set of 30-270
seconds continuous emission limits, a warning tone will be hear in the due time.
1. press the MENU and ENT button;
2. turn the Encoder knob until 'TOT?'(menu 09) is displayed
3. push ENTER;
4. turn the Encoder knob to select from OFF, 30, 60, 90, 120, 150, 180, 210, 240,
270.
5. press ENTER
6. press the VFO/MR knob to exit
Voice function
With this function, you activate a voice that informs about any
operation/selection you are doing. To activate or select it. Follow these steps:.
1. press the MENU and ENT button;
2. rotate the Encoder knob until 'VOICE'(menu 119) is displayed
3. push ENTER;
4. turn the Encoder knob to activate or select from CHS, ENG (CHS=Chinese;
ENG=English);
5. press ENTER again;
6. press the VFO/MR to exit.
Select CTCSS and DCS tones
There are 3 kinds
--- RX and TX
--- RX only
--- TX only
1. Press the MENU and ENT button;
2. rotate the Encoder knob to item 12/13/14 until 'C-CDC? 012'(setting RX/TX
tone), 'R-CDC? 013'(setting RX tone), 'T-CDC? 014'(setting TX tone), is
displayed
3. push ENTER;
4. turn the Encoder knob and select the desired CTCSS tone, or press side key 3
to select DCS tone,
(While selecting the codes, if you press side key 4, you will select the
normal (N) or inverted (I) DCS codes.)
5. press ENTER to confirm and VFO/MR to exit ;