- ページ 2
おもちゃ High Tech Modellbanhen 3002のPDF 使用方法をオンラインで閲覧またはダウンロードできます。High Tech Modellbanhen 3002 2 ページ。 Red backlights 2-axle up to 16 volt
ページを印刷する
Art-Nr: 3002 Red backlights 2-axle up to 16 volt
12. For reassembling the wheels, use the tweezers again. The
model has to lie securely and backwards on the locomotive
repairing fixture. Put the axle on the spot where it is usually
held by the clamp, figure 3. Watch for the correct polarity!
Figure 6 and 7. Now use your tweezers to bend open the
clamp at the side away from the current collector by imposing
pressure on the axle and push in the wheels, figure 4. Finished
– all done, figure 5.
13. For running your trains properly, the right polarity is very
important. Axles built in the wrong way cause short circuits
with high currents that can destroy the fine current collector
springs. An axle of a 2-axle car is always built in correctly
when the uninsulated side of the wheel – the side that shows
pure metal – is on the side where the current collector spring is
pointing at. Figure 6 and 7. Please keep this in mind very well
since it is very important in order to prevent damages.
14. The current collectors are our own design and something very
special. A compromise had to be found between the elasticity
of the metal and the contact pressure of the spring. Of course
a high contact pressure guarantees a good current collection.
This is no problem with powered locomotives, the engine
easily surmounts this frictional resistance. With wagons pulled
by a locomotive things are a bit more difficult. Concerning our
current collector, we have given preference to the elasticity of
the metal, and so to a low contact pressure. The very thin and
flexible material has the ability to abut with a strong bending,
but with low pressure, evenly and securely on the axle. This is
why the spring is strongly bent forward, see figure 8. It can
happen that this bend disappears in the course of time. So
always check the spring when cleaning the wheels and if
necessary bend the spring again as shown in figure 8. Don't
be afraid, the material is suitable for this and due to the low
contact pressure the wagon, in spite of its light weight, won't
be lifted by the spring.
15. High Tech Modellbahnen manufactures its products with the
greatest possible care. We issue a guarantee and warranty
according to legal regulation. Should you find any new product
you just bought defective, please contact your local dealer.
16. If one of our products has been damaged or breaks, please
contact us your local dealer as well. He often might be able to
save it, while own attemps to repair it might lead to a total
economic loss.
Now enjoy your new car with backlights.
High Tech Modellbahnen
97456 Hambach
www.z-hightech.de
Instructions
figure 3: The axle ready to be built in, lying on top of
figure 4: Pushing the axle into the clamp with
figure 5: The axle has been pushed under-
figure 6: The insulated side of the wheel, turned to the
figure 7: The uninsulated side–always on the side where
figure 8: The correct position of the current
page 2
the clamp
the help of some tweezers.
neath the clamp holding it in its place.
opposite direction of the current collector
the current collector is located. Very important!
collector without the axle