- ページ 13

ペットケア製品 High Tech Pet BE-500のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。High Tech Pet BE-500 17 ページ。 Wire and flag kit

TROUBLESHOOTING PROCEDURES

If any part of the system is not working use the following

troubleshooting procedure to isolate the failed component.

Then contact High Tech Pet Products Customer Support to

get it repaired or replaced.

Test Base Station Transmitter

First disconnect the boundary wire loop from the

base station transmitter by lifting the small door on

the bottom of the transmitter and pressing the two

wire connection buttons (one is black the other is

red) while pulling gently on the wires.

Apply power to the transmitter and verify that the BREAK

DETECTION circuit indicates a break. There will be an

audible alarm and a message on the transmitter face. If a

break is NOT indicated, the base station transmitter has

failed – repair or replace.

Make a Test Loop Wire as follows: Strip 1/2. inch

of insulation from the two ends of a 2.4-inch-long

piece of spare insulated wire. You can use any

gauge wire.

Attach the Test Loop Wire to the loop terminals (black

and red) on the bottom of the transmitter. Apply power

to the transmitter and verity the BREAK DETECTION

circuit does NOT indicate a break. There should be no

audible alarm and no Break message on the transmitter.

If a break is detected the Base Station Transmitter has

failed – repair or replace.

Test all Humane Contain Collar

e) With the TEST Loop Wire attached and the transmitter

powered adjust the transmitter Boost Power switch to

normal (NOR) and the Field Strength Control knob to

maximum (fully clockwise). Now