- ページ 4

インバーター Autopilot APCG8NGのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Autopilot APCG8NG 13 ページ。 4 burner co2 generator (lp or ng)

Page 3

APCG4

Installation

Determine the best location for the generator. It must be hung

level in an area that is adequately ventilated.

!!Warning!! In closed spaces without adequate ventilation,

CO2 levels can accumulate and become toxic (CO2 levels

above 5000 PPM are toxic) Plants benefit from levels up to

1500PPM. Levels above 2500PPM can cause headaches

and /or other feelings of being ill.

The generator requires an unrestricted flow of air through the

bottom and must be hung. DO NOT set the generator on top

of anything such as a table, stand, etc.

Select an overhead support such as a ceiling joist to hang the

generator from. The unit must have a 20" minimum space

between the unit and wall, roof or any other possible

obstruction.

Use the provided hardware (20" chains, screw hooks, and S

hooks) to securely hang the generator.

Install the screw hooks into the overhead support. Use the S

hooks to secure the chain to the unit and the screw hooks.

Bend the S hooks so that they are secure.

Verify the APCG4 is hanging level. The APCG4 has a safety

feature, the "tip over" switch, which will turn off the burners if it

tips over or falls. The switch is like a pendulum and will turn off

the unit if it is not level.

Verify the gas supply, and the regulator being used match the

type of generator (NG or LP) selected.

Securely tighten the gas connection with 2 wrenches, using

the included 12 foot hose, connect one end to the flare fitting

and the other to the provided gas regulator. Verify connection

is secured safely.