- ページ 12

室内暖炉 Dynasty Fireplaces DY-BEF57のPDF ホームオーナー用設置説明書＆取扱説明書をオンラインで閲覧またはダウンロードできます。Dynasty Fireplaces DY-BEF57 15 ページ。

NOTE：The flame will always on when the appliance is on.

Main power switch

The POWER switch supplies power to all of the functions of the fireplace. This switch must be

in the "ON" position for any of the functions including the remote to work.

Power button

By pressing the POWER button, turn the fireplace on when it is off or turn it off when it is on.

Flame button

By pressing the FLAME button, the unit will cycle through five flame effects.

Fuel bed button

By pressing the FUEL BED button to cycle through 14 fuel bed effects.

Heater button

Press once turns Fan on, and 8s later Low heat on. (Pilot lights illuminated ●○)

Press again turns on High heat. (Pilot lights illuminated ●●)

Press third time turns heat off. 8s later fan off (Pilot lights illuminated ○○)

There are 3 levels you can cycle through including the OFF setting.

To Reset the Heater

Your heater includes a protection system that shuts off the heater if it overheats for any reason:

1) Turn unit to off.

2) Unplug unit wait 5 minutes.

3) Plug in and turn on.

●

Operating by Remote Handset

In order to protect the product from becoming too hot, there is a 8s delay when

turning on the heater; also there is a 8s delay when turning off the heater fan.

 Make sure the batteries are installed properly in the remote control.

 The effective range of the remote control is up to 4 meters or 13 feet.