- ページ 8

ワイヤレスルーター High-Flying HF-LPD100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。High-Flying HF-LPD100 16 ページ。 802.11a/b/g/n wifi module

HF-LPD100 Low Power WiFi Module User Manual

<Notes>

I — Input；O — Output

PU—Internal Resistor Pull Up； I/O: Digital I/O； Power—Power Supply nReload

When this pin is set to "low" during module boot up, the module will enter wireless

firmware and config upgrade mode. This mode is used for customer manufacture.(See

Appendix to download software tools for customer batch configuration and upgrade

firmware during mass production)

After module is powered up, short press this button (0.2s < "Low" < 1.5s) and loose to make

the module go into SmartLink V8 config mode, when in SmartLink V8 config mode and short

press this button again to go into SmartAPLink config mode, waiting for APP to set router

SSID and password, config module connect to router. Recommend to use SmartAPLink

method config.

See Appendix to download SmartLink V8 and SmartAPLink APP

After module is powered up, long press this button ( "Low" > 4s ) and loose to make the

module recover to factory setting.

High-Flying strongly suggest customer fan out this pin to connector or button for

"Manufacture" upgrade or " SmartLink" application.

nReady Pin (LED) function(Low effective)：

OS initial finished indicator. Only after this pin output low, can the UART function be used.

nLink Pin (LED) function(Low effective)：

1. At wireless firmware and config upgrade mode , this LED used to indicate configure and

upgrade status.

2. At "SmartLink" config mode, this LED is used to indicate APP to finish setting.

3. At normal mode, it's Wi-Fi link status indicator. Output Low when STA mode connect to

router AP or other STA connect to it when in AP mode.

High-Flying strongly suggest customer fan out this pin to LED.

UART1 Debug ：

1. Is used for debug log

High-Flying Electronics Technology Co., Ltd.(www.hi-flying.com)

Pin (Button) function：