- ページ 6

電気ヒーター Dynasty Fireplaces EF57USのPDF ホームオーナー用設置説明書＆取扱説明書をオンラインで閲覧またはダウンロードできます。Dynasty Fireplaces EF57US 9 ページ。 Electric heater with remote control

Magnet

1.5 Install the front onto the insert by locating the pole on both sides well, and slightly push the trim

bottom to fit the engine by magnets. Installation is completed.

2. With front TE3/TE4

2.1 Fix the insert into the mantel as step 1.2 & 1.3 & 1.4, locate the front onto the engine by the pole on

both sides and push down, then fix the trim by 2pcs of ST4*8 screws.

Plug the power supply cord into a wall outlet (120Vac, 60Hz).The cord has a plug as shown at A.

You should follow as shown at the below:

ELECTRICAL CONNECTION

A 15 AMP, 120 Volt, The unit comes standard with 6 feet (1.8 m) three wire cord, exiting from the rear of

the fireplace. Plan the installation to avoid the use of an extension cord. Preferably, the fireplace will be

on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the

fuse to blow when the heater is in operation.

Pole

GROUNDING

Grounding methods

Screw ST4x8