- ページ 8
GSM/GPRSモジュール Autoplugin RCP-FMのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Autoplugin RCP-FM 12 ページ。
ページを印刷する8. Settings
reset
9. Heater
errors reset
* Factory setting
Recommended settings is marked in italics
2
–RCP turns off the heater if the battery voltage becomes lower than preset
4
– Signals appear only at the heater's autonomous operation
5
– Signal is used for indication by all the hazard flashers. It uses 1-wire connection
to the hazard alarm button (see installation manual for details).
6
– Additional connections required (see installation manual), not available by
using plug-n-play cable
7
– For the car's remote key only
Signals
The module has two connectors: 9-pin connector X1 (table 3) for input signals and
power connection, 10-pin connector X2 (table 4) for output signals, special signals
and CAN-bus connection. The first pin on each connector is marked by the key.
X1 pin
Signal Name
number
1
Heater_off+
2
Heater_off-
3
Heater_on+
4
Heater_on-
5
Button
6
Timer _in
7
RC_in
8
Ground
9
Battery Power
The signals to be necessarily connected marked in the table in Italics
8
7.6.4 Ignition on (potential)
7.6.5. Disable the output
7.6.6 Feedback for Defa Vehicle Unit
8.1.1 Apply factory settings
9.1.1 Clear all errors in heater's memory,
resulting heater unblocking
Polarity
+
-
+
-
-
+
+
Table 3
Wire colour
White
Grey
Green
Blue
Brown
Orange
Yellow
Black
Red