- ページ 2

ホットタブ Dynasty Spas Excalibur SC-MP-DY1/Dual-Pump SystemのPDF クイック・リファレンス・カードをオンラインで閲覧またはダウンロードできます。Dynasty Spas Excalibur SC-MP-DY1/Dual-Pump System 2 ページ。 Excalibur series

ページを印刷する

PROGRAMMINGFILTERCYCLEDURATION

The system automatically performs two filter cycles per day, at 12-hour intervals. During a filter cycle:

• Pump 2 runs for one minute, then

• Pump 1 runs at low speed for the programmed number of hours

The "Filter Cycle" indicator lights up when the filter cycle is on.

To set filter cycle duration:

Press and hold Filter key

until the display shows "xx",

representing the currently

set filter cycle duration in

hours.

The filter cycle is suspended if the water temperature

raises more than 2˚F (1˚C) above Set Point or if spa

is in use (pumps and light started manually). The "Filter"

icon will blink (on 0.5 second, off 0.5 second, on 0.5

second, off 1.5 seconds).

TROUBLESHOOTING

Pumps have started up for one

minute on several occasions and

"Filter Cycle" indicator is flashing.

3 flashing dots are displayed.

Water temperature is flashing.

The display is flashing.

Use Up or Down arrow keys

to change setting.

0 = no filtration

12 = continuous filtration

N.B.: After a power failure, the filter cycle duration

will return to its default value (2 hours). In this case,

the first filter cycle will start one minute after power

has been restored.

Not a bug but a feature!

Our Smart Winter Mode protects your spa from the

cold by automatically turning pumps on for one minute

several times a day to prevent water from freezing in pipes.

A problem has been detected.

Do not enter the water! Check and open water valves.

Clean filter if necessary. Check water level. Add water

if needed.

Shut power off and power your spa up again to reset the

system.

Call your dealer or service supplier if problem persists.

Water temperature in the spa has reached 112˚F (44˚C).

Do not enter the water! Allow water to cool down. The

system will reset automatically when water temperature

reaches 109˚F (43˚C).

Call your dealer or service supplier if problem persists.

A power failure has occurred.

Press any key to reset the system, then reprogram all

desired parameters.

When the desired setting is dis-

played, press Light key to confirm.

A filter cycle starts immediately.

Note: Light needs to be turned

off before the filter cycle can be

programmed.

Smart

Winter

Mode

9919-100418-B