- ページ 8

GPS GalileoSky Base Block Hard Wi-FiのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GalileoSky Base Block Hard Wi-Fi 10 ページ。

Connection of Galileosky Base Block Hard Wi-Fi

(version 4 dated from June 28, 2018)

Setting of the Tracking device

Before operating with Galileosky Base Block Hard Wi-Fi you should carry out its setting in

service program "Configurator" (hereinafter-Configurator). Perform the following actions:

1. apply operating voltage to the tracking device, connect it to a computer via USB-cable;

ATTENTION!

The tracking device cannot be charged via USB. It should be connected to

external power supply.

2. run "Configurator" and make sure that the tracking device is detected by Configurator (Pic.

4);

3. go to tab "Settings" -> "Data transmission" (Pic. 5)

enter the name of Wi-Fi network in "SSID" field, select authentication type depending



on the settings of router safety (if you set the router independently, WPA/WPA2 is

recommended, as it is a more secure technology), enter the password, if you have one;

set access point of selected service provider; if the fields are not filled, the tracking device



will automatically select a provider from the list in tracking device's archive and will

apply corresponding settings;

set data server and port, which it operates through;



select data transmission protocol, it is recommended to use Galileosky protocol, as it



allows to transmit more data;

click "Apply" button.



Pic. 4

"Device" tab