- ページ 5
アンプ Dynatech V-7000のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dynatech V-7000 16 ページ。 Professional
ページを印刷する
- 1. User Instructions
- 2. Table of Contents
- 3. Safety Precautions
- 4. Introduction
- 5. Front Panel
- 6. Rear Panels
- 7. Inputs
- 8. Outputs
- 9. Speakon Output Connector Assembly
- 10. Operating Modes
- 11. Limiter
- 12. Short Circuit Protection
- 13. Thermal Protection
- 14. Amplifier Features
- 15. Subwoofer and Speaker Setup
- 16. Specifications
Front Panel Control
1. Power Switch - This switch is used to control the units main power.
2. Channel 1 Gain Control - This rotary knob is used to control the out -
put signal of channel one. Turning the knob in a clockwise direction will
increase signal output.
3. Channel 1 Limiter Switch - This is used to activate the channels
built-in limiter. The limiter reduces the average input level when the sig -
nal begins to distort, this process is designed to reduce distortion and
protect the speakers. See limiter page 11.
4. Channel 1 Clip Indicator - This red LED will begin to flash when
channel one begins to overload (clip). At this point channel one will be -
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and amplifier. This
LED may glow when the unit has been turned off, this is normal.
5. Channel 1 Protect Indicator - The red Protect LED will begin to glow
when the channel goes into protect mode. When the channel goes into
protect mode all output for that channel will turn off. This is to protect any
speakers connected to the channel.
6. Function Indicators - These indicators detail the operating mode of
the amplifier. These LEDs will also function as a power indicator.
7. Channel 2 Protect Indicator - The red Protect LED will begin to glow
when the channel goes into protect mode. When the channel goes into
protect mode all output for that channel will turn off. This is to protect any
1
2
3
4
5
6
7
8
PARALLEL STEREO BRIDGE
POWER
LIMITER
ON
PROTECT
ON
CLIP
-5dB
-10dB
OFF
-20dB
SIGNAL
0
10
PROFESSIONAL POWER AMPLIFIER
12
11
speakers connected to the channel.
8. Channel 2 Clip Indicator - This red LED will begin to flash when
channel one begins to overload (clip). At this point channel one will be -
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and amplifier. This
LED may glow when the unit has been turned off, this is normal.
9. Channel 2 Limiter Switch - This is used to activate the channels
built-in limiter. The limiter reduces the average input level when the sig -
nal begins to distort, this process is designed to reduce distortion and
protect the speakers. See limiter page 11.
10. Channel 2 Gain Control - This rotary knob is used to control the
output signal of channel two. Turning the knob in a clockwise direction
will increase signal output.
11. Channel 2 Signal Indicators - These green and yellow LED's will
glow according to the average signal output.
12. Channel 1 Signal Indicators - These green and yellow LED's will
glow according to the average signal output.
page 5
9
10
LIMITER
ON
V-5000
0
10
Diagram 1