- ページ 4

エンジン Autoquip Eco-2MのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Autoquip Eco-2M 12 ページ。 Piston air engine

Start-Up

1. Set air pressure to zero.

2. Set any speed restrictor valves to the fully open position

3. Slowly increase air pressure until the shaft rotates under load.

4. For low load applications, increase air pressure by a further 1 – 1.25 bar (15 – 20

psi). This may not be necessary for high load applications.

5. Adjust the speed restrictor to give the required speed.

6. The air engine will now be running at the optimum and most efficient setting.

Note: It is bad practice to apply excessive line air pressure and then have a tight restriction on the

exhaust port. This can cause excessive wear on the base of the pistons.

Recommended Lubricants

Shell Gadus S2 V100 3

Autoquip Piston Air Engines

are precision engineered and are designed for a long

™

working life. The wearing parts are the pistons, cylinder liners and seals, which can be

replaced as part of a routine maintenance schedule.

For this purpose, spare parts kits can be purchased from Autoquip Automation or our

authorized distributors, comprising three pistons, three liners, three piston seals and

three O Rings.

The drive shaft and rotary valve assembly are matched during manufacture and should

not be removed from the engine body. If they are removed, they will require

replacement with new parts in our factory.

As with all precision engineered machines, cleanliness is essential during dismantling

and assembly. Before dismantling, the air supply ports must be covered with plastic

caps and the workbench should be clean and free of debris.