- ページ 9

クックトップ DCS DCS-C-24WのPDF ケア＆インストール・マニュアルをオンラインで閲覧またはダウンロードできます。DCS DCS-C-24W 17 ページ。 Wok cooktop
DCS DCS-C-24W にも：ケア＆インストール・マニュアル (18 ページ)

ページを印刷する

BACKGUARD INSTALLATION - TEST & ADJUSTMENT

STEP 6: BACKGUARD INSTALLATION

The backguard must be installed when there is less

than a 12" clearance between combustibles and

back edge of cooktop. For island installations and

other installations with over 12" clearance, and

optional stainless steel trim channel is available to

cover the backguard mounting flanges.

Refer to Fig.12

A. Slide backguard over the 2 flanges on the rear

of the appliance. Fasten the back with two screws

(See A Fig.12) provided. No screws are required

behind the wok section.

B. Fasten the top of the backguard to the wall

with two screws through the backguard (See B.).

C. Place the backguard cap on top and fasten

using the two counter-sunk screws provided.

FIG. 12

HEADER

STEP 7: TEST & ADJUSTMENT

Check for proper burner flame characteristics and

adjust the air shutter if necessary. Each burner and

valve is individually checked at the factory prior to

shipment but variations in local gas supply may

make adjustment necessary.

Burner flames should be blue and stable with no

yellow tips, excessive noise or lifting. If any of

these conditions exist, check that the regulator is

installed with the arrow pointing towards the appli-

ance, and that it is 5.0 inches w.c. Nat. gas; and 10.0

inches for propane.

If this condition persists, the air shutters should be

adjusted. Begin by removing the valve panel using

the access hole provided, loosen the air shutter

locking screw on the face of the burners mixing

head.

If the flame is too yellow, indicating insufficient air,

adjust the shutter to increase the air inlet.

If the flame is noisy or tends to lift away from the

burner, indicating too much air, adjust the shutter to

decrease the inlet.

The burner flame should be 1-1/2 to 2-1/2 inches

high.

Adjustable - Low Setting:

The open top burner valve used on your cooktop

has an adjustable low setting. Each valve is individ-

ually tested and adjusted on the appliance prior to

shipment. Due to fluctuations in gas pressure and

heating valve, you may feel it necessary to increase

or decrease the gas flow at the low position.

FIG. 13