- ページ 7

ストレッチ包装システム GALLERY STRETCHER-240のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GALLERY STRETCHER-240 17 ページ。

Position the frame so that it is against the "mechanical stops", the short tab of metal about

1/8" high (these stops also facilitate alignment during the stretch). Loosen the (4) screws

on each of the slotted stretcher plates.

Apply air to your machine and verify that the clamping bar is open. Move the assembled

frame and the plates together in and out until the face of the wooden frame is

approximately ½" behind the angle bar. In other words, create a gap so the canvas will

"waterfall" down into the opening when the clamp is closed. This step (above and below)

is simulated without the canvas present.

Tighten all of the screws. This setting will not change for any stretcher bar that is this

width. This procedure would only need to be done again if you change to a different

width of stretcher bar.

This is referred to as the "Loaded Position"