- ページ 10
スピーカー Dynaudio BM 6A mkIIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dynaudio BM 6A mkII 12 ページ。 Monitor system
Dynaudio BM 6A mkII にも： オーナーズマニュアル (7 ページ), ユーザーマニュアル (15 ページ)
ページを印刷する
Troubleshooting
If Power LED lights green and no sound, check
your input signal f.ex. by switching speakers.
If power LED does not light at all and no sound,
check the fuse. If replaced and still no sound
contact your Dynaudio Acoustics Dealer.
If protection LED lights red check the
temperature of the heat sink. If it feels hot turn
off the speaker and wait for some 10 minutes to
allow the amplifier to cool off. Turn it on again.
If it works now it is ok, but you may need more
air circulation around your speaker to avoid
overheating to take place again.
Care
Components of the highest quality is used in
your BM 6A mkII. This assures years of trouble
free operation. Following precautions should
still be made though.
Avoid running the system into severe clipping.
Even there is an advanced protection system,
you may be able to destroy your speakers by
severe overpowering. When a noticeable
distortion occurs, please turn down the level to
your speakers.
Avoid hot plugging the equipment connected to
the monitors. Always turn off the speaker and
other equipment when plugging or unplugging
signals, or switching equipment on or off.
Do not touch the drive units by hand. The
tweeter especially uses a very fine fabric dome
with a ultra thin coating.
Options
The BM 6A mkII may be combined with a
Dynaudio Acoustics subwoofer for extended
bass performance, and higher spl if highpass
filter is used. See Setting Up.
8
MISCELLANEOUS
Service
There are no user serviceable parts inside the
monitor. If service is required please contact
service via:
www.tcsupport.tc
or
TC Electronic
Sindalsvej 34
DK-8240 Risskov
Denmark
Tel: +45 87427000