レンジ DCS RGSC-305のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DCS RGSC-305 8 ページ。 Lp/natural conversion kit for rgsc-305 professional range

LP/NATURAL CONVERSION KIT INSTRUCTIONS

RGSC-305 PROFESSIONAL RANGE

Before you begin, read these instructions completely and carefully.

WARNING

This conversion kit must be installed by a qualified service agency in accordance with the

manufacturer's instructions. All applicable codes and requirements of the authority

having jurisdiction must be followed. If the information in these instructions is not

followed exactly, fire, explosion or production of carbon monoxide may result, causing

property damage, personal injury or loss of life. The qualified service agency is

responsible for the proper installation of this kit. The installation is not proper and

complete until the operation of the converted appliance is checked as specified in the

manufacturer's instructions supplied with the kit.

PARTS INCLUDED

Broil Burner Orifice (1)

Conversion Sticker (1)

Valve Stem C-Clip (5)

CAUTION:

Before proceeding with the conversion, shut off gas supply to the appliance prior

to disconnecting the electrical power.

GAS SUPPLY

Measure the incoming gas pressure to the regulator.

With the installation of this conversion kit, the range should operate on LP gas at 10" of water column pressure

and on natural gas at 5" of water column pressure.

The pressure regulator must be connected in series with the manifold of the range and must remain in

series with the supply line.

When checking the regulator, the inlet pressure must be at least 1" greater than the regulator output

setting.

- If the regulator is set for 10" of water column pressure, the inlet pressure must be at least 11".

For proper operation, the maximum inlet pressure to the regulator must be no more than 14" of water column

pressure for LP gas and 9" water column pressure for natural gas.

CKL-RGSC305 Natural to LP

CKN-RGSC305 LP to Natural

TOOLS NEEDED

1/8" Flat-blade Screwdriver

Adjustable Wrench

7mm Nut Driver

4mm Nut Driver (included)

Phillips Screwdriver

Ratchet with 1-1/16" Hex Deep Socket

25/32" Socket

1/2" Deep Socket

Manometer