- ページ 12
サブウーファー Dynaudio 9SのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dynaudio 9S 18 ページ。 Precision bass, optimised for the studio
ページを印刷する
POWER
ON
AUTO
SAT Highpass
Flat
60Hz
SAT/SUB Input
LEFT
RIGHT
LFE / Slave IN
SUB I/O
LFE
Adjusting the volume
(Gain)
High sound levels can cause auditory
defects. To avoid auditory period of time.
defects, do not listen to high sound
levels over a longer period of time.
CAUTION
High Sound Levels!
The correct volume setting is an
important aspect in achieving a well
balanced speaker combination.
To adjust the gain:
Adjust the Gain control, until correct
setting is reached.
22
GAIN
PHASE
0° 180°
Min
Max
SUB Lowpass
80Hz
GAIN
50Hz
150Hz
SAT Output
Min
OUT
To Slave
Slave
Note
You cannot adjust the volume
when the subwoofer is in slave
mode. In this case the volume is
controlled by the setting of the
master subwoofer.
Max
Selecting the subwoofer
cut-off frequency (Lowpass)
The Lowpass control allows the
frequency range of the subwoofer to be
defined. Above the selected frequency
the sound level decreases rapidly. the
correct setting of this cut-off frequency
is important for a well balanced
combination of subwoofer and speakers.
To select the cutoff frequency
Set the Lowpass control to the
desired frequency between 50 and
150Hz.
POWER
GAIN
PHASE
ON
AUTO
0° 180°
Min
Max
SAT Highpass
SUB Lowpass
Flat
60Hz
80Hz
SUB Lowpass
50Hz
150Hz
SAT/SUB Input
SAT Output
LEFT
50Hz
RIGHT
LFE / Slave IN
OUT
SUB I/O
To Slave
LFE
Slave
Notes
•
The Lowpass only works on SAT/SUB input.
•
Perhaps subwoofer cut-off frequency is already set in the bass management
of your source. Please refer to the operating manual of your source. In
general use only one bass management system.
You should also heed the instructions given in the operating manual of your
loudspeakers.
Operation
150Hz
23