安全装置 Highnovate BELLAのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Highnovate BELLA 3 ページ。 Remote controlled anchor
Highnovate BELLA にも：使用方法 (2 ページ), 使用方法 (2 ページ)

ページを印刷する

A REMOTE CONTROLLED ANCHOR

GENERAL INSTRUCTIONS

Use only standard gear, checked by a

certified person.

Use the product only after proper training

from a certified guide.

Do not use the product without reading the

instructions.

Check the product functionality before

every use. If there is any doubt, do not use

it until consulting with the manufacturer.

Anchor the product to a firm structure using a

telescopic pole or directly to a standard anchor

point. Use a carabiner to connect the "head" of the

Bella to the anchor point.Make sure the anchor is

strong enough to support the loads that might occur

during a dynamic fall and that it is stable, structural

element.

When using a pole – lift the pole up to the anchoring point,

while the throw bag and rope adapter stays on the ground.

Make sure the hook which the head is connected to is firmly

attached to a part of the structure. (beam or rail). When using

other methods of anchoring ( for example using a webbing or

sling wrapped around a structural element (beam or rail)) after

anchoring and connecting the head, throw the bag so the tag

line will reach the ground. Lower the rope adapter to the

ground.

Connect a rope/ladder/rescue kit to be lifted to the anchoring

point using a carabiner to the pin.

Pull the tagline until the rope adapter and

the rope connected to it will reach the

head. Make sure the rope adapter got to its

place inside the head and created an

anchor.

BELLA

TAG LINE

METHODE OF USE

Anchoring using a webbing

Clipping a carabiner helps to avoid

obstacles

KIT PARTS

HEAD

PIN / ROPE

THROW

Anchoring using a hook and pole

Throwing the bag

after connecting the

head to the anchor

Rope connection using a

carabiner

pulling the rope to

Final position of the

connect the parts

anchor

ADAPTER

BAG