- ページ 10

冷蔵庫 DCS RF24REのPDF 設置、操作、メンテナンスの説明書をオンラインで閲覧またはダウンロードできます。DCS RF24RE 20 ページ。 Outdoor refrigerator

ページを印刷する

Alarm

Set

Colder

Warmer

Press and Hold

Figure 10

close-up of

control

Starting your refrigerator

Plug the refrigerator power cord into a wall outlet. Your

refrigerator will begin cooling after power is applied.

If your refrigerator does not start, check that the refrigerator

is turned on and the set temperature is cold enough.

Turning your refrigerator ON or OFF

If the refrigerator is on, the refrigerator temperature will be

shown on the display. To turn the refrigerator off, press and

hold the "ON/OFF" button for three seconds. "OFF" will ap-

pear on the display.

If the refrigerator is not on, "OFF" will be shown on the

display. To turn the refrigerator on, press and hold the "ON/

OFF" button for three seconds. The refrigerator tempera-

ture will be shown on the display.

Set temperature

To set the refrigerator temperature, press and hold the

"SET" button. When the "SET" button is pressed, the

display will show the set temperature. While holding the

"SET" button, press the "WARMER" or "COLDER" buttons

to adjust set temperature.

Refrigerator operation

The available temperature range of the refrigerator is 34° to

42°F (1° to 6°C).

It may take up to 24 hours for your refrigerator to reach

desired temperature. This will depend on amount of content

loaded and number of door opening and closings.

For best results allow refrigerator to "pull down" to desired

set temperature before loading. Once contents are loaded,

allow at least 48 hours for temperature to stabilize before

making any adjustments to the set temperature.

USING YOUR ELECTRONIC CONTROL

ON/OFF

Press and Hold

Alarms

Your digital display function will monitor refrigerator function

and alert you with a series of audible and visual alarms.

•Door Ajar Alarm: If the door has been left

open for over five minutes, the alarm

will sound in one second intervals. The

display panel will flash "do" and the Alarm LED located at

the top left of the display below the word "Alarm" will be il-

luminated. This will stop as soon as the door is closed.

• Temperature Sensor Fault: If the control-

ler detects that the temperature sensor is

not properly functioning, a temperature

sensor alarm will sound in one second intervals. "E1" will

flash on the display panel and the Alarm LED located at

the top left of the display below the word "Alarm" will be

illuminated.

Alarm Mute

Press any key to mute the audible portion of an alarm.

NOTE-This action will only mute the alarm. If the condi-

tion that caused the alarm continues, the alarm code will

continue to flash and will sound for 20 seconds every 60

minutes.